V
vr1967
Latest activity Postings About
-
-
Vvr1967 replied to the thread need 208C case front 1/2.I thought I had one, but am only finding the rear 1/2 of the case.
-
Vvr1967 replied to the thread Cruise Control Linkage Needed for an 87 tbi.This should be it. About 8” long. Adjusts by hand, so not frozen up. @Hunter_Michael
-
-
Vvr1967 replied to the thread Cruise Control Linkage Needed for an 87 tbi.I’ll try to remember to look tomorrow. Believe I still have the cruise stuff from an 89 Blazer I parted
-
Vvr1967 replied to the thread Wife’s new toy.Picked up some used wheels (17x9) and tires as 3 of the steel wheels that was on it has pin holes rusted in them. She is not sure yet...
-
-
VDid someone say Soddy Daisy? I may be biased, but I highly recommend it.
-
Vvr1967 replied to the thread Hello from Tn.Welcome from SW MS. I get to mid Tenn a good bit and have looked for land east of there around the Monteagle to Jasper area.And as far...
-
Vvr1967 replied to the thread Needing help locating an air filter duct.I’ll look as I still may have the one off the 88 CC that I still own, as it was a 454 truck
-
VI did for sure install the correct pilot bearing. Test fit on the shaft before it went in.
-
Vvr1967 replied to the thread What did I do wrong? NV4500 Swap Issues.Looks like there is no pilot bushing installed in this photo. Be sure to install one if you haven’t already
-
Vvr1967 replied to the thread 84 OEM Cruise Control Module/LS Swap.Here is how I am looking into doing my next set up. It’s s10 but the full size stuff is almost, if not same...
-
Vvr1967 replied to the thread 2000 6.5 turbo on a 82 6.2 diesel?.Do you have factory a/c on your 82? The 6.5 turbo setup will hit the ac box. If your truck just has the heater, it will be fine. The...
-
Vvr1967 replied to the thread Camber issue.In the 80s, we’d cut a square out around the lower ball joint, cut 5/8” out behind the ball joint, then weld the ball joint piece of the...
-
Vvr1967 replied to the thread 87 v3500 6.2 engine replacement.What is your plans / use for the truck? We still find running 6.2 pullouts reasonably priced here in SW MS. Without a turbo, they are...
-
Vvr1967 replied to the thread K10 Evaporator Box.I’ve probably got 1 or 2 spare boxes in the barn. Will try to remember to look when I get home from work
-
VWife mentioned a while back that she would like an old Bronco or Scout, since her father had both when she was growing up. Visited a...
-
-
-
Loading…
-
Loading…
