CheemsK1500,
I had an auto paint supplier mix me a color match to the back side of a trim panel that never would have been sun fade. So I can paint but I‘m worried about the flexible parts not holding up I guess. Just seams odd all the parts are showing up this shade of blue? I’m missing...
Just opened the LMC belts I ordered and they are dark blue and nothing like the original light blue belts. Was there a dark blue interior option also in 73-81? The carpet I received is the correct light blue…
I just finished adding Holley EFI gauges to my 77. These are CAN bus gauges and I’m guessing not compatible with your Pro flow but you could use any gauge manufacturer with your existing dash for the same affect.
I’m looking to repaint the plastic trim on my 1977 Cheyenne with blue interior. LMC only lists Colorbond-blue 37-8382. I ordered some but it’s not even close. The attached picture shows the original color in the middle. Left side is sun faded and the right side is the LMC color. has anyone found...
RecklessWOT,
Thanks for the clarification. I heard the term headache rack used incorrectly as a kid and never really thought about it... It's a sturdy rack that I will use very little on this truck other than long boards from time to time. I plan on fabricating a removeable front bumper rack...
Nasty,
Im having the same issue with my swap the total travel range does not allow my 4l80 to hit 1st. I could adjust it to get first but can’t make park then. I relocated the linkage pivot on the frame and extended the rod but will need to make a small change to the rod length at the trans or...
I finished my spring replacement and lowering this week. Used CCP Modular spindles with 2” drop springS and a axle flip in the back. Also picked up the headache rack for $100.
Well not a perfect solution but much better than it was. I used some fake wood tape and trimmed with a razor knife. My choice of red oak was not as close a match as it could have been. I also added a leather rap.
Sorry to raise the dead but has anyone found a solution for restoring the wood inlay on a factory wheel. I just finished cleaning up and painting my 1977 wheel with wood inlay.
Thanks 1979 c20 I figured that was the case. I purchased the truck as a shell. Glad I never drove it that way. anyone have a recommendation for the replacement springs. I assume I will need to do a axle flip to match the CCP modular 2.5” drop springs and 2” drop coils I have on order.
Well I’m almost done with the LS6.0/4l80 swap. I’m just waiting for the back ordered exhaust. Started looking at the height I wanted to lower it and found 4.5“ in front and 4” in the rear would be level and a height I like. That sounded like the rear was lower than normal already. So I started...