-
-
Bextreme04 reacted to legopnuematic's post in the thread Think I found a somewhat rare truck with
Like.
I’d say you’d be more likely to find a short bed step side 454 C10 that does have the F44 rpo (big ten/heavy half) than not, as (until... -
I don't see any mention of a compression test being done but have you performed a compression test on each cylinder? That would maybe...
-
Years ago I pimped out my CUCV Blazer with a silverado gauge cluster. All I did was de-pin and re-pin the plug end and follow the path...
-
Bextreme04 replied to the thread Remove O2Sensor.This is the way
-
Bextreme04 replied to the thread Remove O2Sensor.Usually one tank of gas will do it.
-
Hi thanks for the replies I sprayed it with PB Blaster for a week, drove it to work every day 8 miles each way and keep soaking it. I...
-
Bextreme04 reacted to Sad Sack's post in the thread Needs MORE POWER!!! (Tim Taylor Style!!!) with Haha.
Old school is throwing a handful of mothballs in your gas tank!
-
Bextreme04 replied to the thread Needs MORE POWER!!! (Tim Taylor Style!!!).There's only two real solutions to this problem. The first one is displacement.. there really is no replacement for displacement. Drop...
-
Bextreme04 reacted to HotRodPC's post in the thread I would really like a turbo 400 in my truck with Like.
Good to know. This is my project for my K1500 to K2500 axle conversion. I already have the Th400/NP208 married combo, just that the...
-
Unbolt the tank with the brackets,reach up with pruning shears,cut your hoses,use new hose going on. These really aren't a big deal I...
-
Bextreme04 replied to the thread I would really like a turbo 400 in my truck.I have a Figure 8 NP205, so that's what I needed to do. I swapped in a long 2wd output shaft when I rebuilt the 4L80 and added the rear...
-
Bextreme04 reacted to txaggie's post in the thread I think a rod spun a bearing in my rebuilt 454 with Like.
That’s my issue. This shop already had to refund me for bad head work on the same install. Looks like they can either refund me for...
-
Bextreme04 replied to the thread Need a breather for my 1987 7.4L "N", ideas?.These guys seem to have exactly what you are looking for. NOS or take-off used parts...
-
Bextreme04 replied to the thread fuel line clamps.The feed and return are zero PSI.. feed should actually be a vacuum most of the time. The only line on the pump that sees pressure is...
-
Bextreme04 replied to the thread Is this a good pattern for gm 14 bolt ff?.Looks great to me. That's pretty much exactly what mine looked like when I rebuilt the rearend a few years ago. Factory 8600GVW K25 with...
-
-
Loading…
-
Loading…
