Bextreme04's latest activity
-
Woohoo! I found one about a mile from home for 150 bucks!! Yay! I also found another one is West Richland if anyone is interested -... -
Bextreme04 replied to the thread WANTED: Canopy for K20.I see them all the time around here. I'll keep an eye out for you. You might try hitting up ChadTheMan on facebook also. He has a...
-
Bextreme04 reacted to txaggie's post in the thread 4l80e conversion in 1985 suburban. What parts do I need? with
Haha.
Found the issue. Shudder is most likely a burnt plug wire and dead cylinder: -
Bextreme04 replied to the thread Need help identifying 12v wire for electric choke.The factory setup in the later 80's models used a two prong NO oil pressure switch mounted in the 1/8 NPT port right above the oil...
-
Bextreme04 replied to the thread Changing An Automatic Flywheel Without Removing the Transmission.I had to do this on my LS when I forgot to torque the flywheel bolts on a 5.3 to 6.2 swap. I bought 4-1/2" long bolts from the hardware...
-
Hey Justin, load up your truck and meet Bucket and I at Richmond Indiana Square body show July 25-26!!
-
Was running fine, had a bit of an exhaust by passenger side manifold/down pipe joint. On the freeway this morning, 10 miles in, she...
-
On a TBI I would start with the fuel system. Does the pump run when you key it on? If the filter has not been changed recently, change...
-
Bextreme04 reacted to Sad Sack's post in the thread What have you done to your square lately?? with Like.
Flex Tape - Clear
-
Bextreme04 replied to the thread What have you done to your square lately??.That looks exactly like the C.R.Lawrence back glass I got out of a junkyard for my truck. All aftermarket sliders use the factory...
-
Bextreme04 replied to the thread What have you done to your square lately??.It's a high temp because its in the pressure test port. That is the absolute worst place to put a temp sensor and borderline useless...
-
Thank you, SIr. Edit: Napa has the 15 amp. Thanks again!
-
Bextreme04 replied to the thread Evaporator Housing Cover Necessary?.I got both from O'reilly. They have a 30/40 Amp one listed or a 15 Amp. I assumed the 30/40Amp was the correct one and it was not. The...
-
Bextreme04 reacted to AuroraGirl's post in the thread Evaporator Housing Cover Necessary? with Like.
its part of the extra insulation that diesels got
-
Bextreme04 replied to the thread Evaporator Housing Cover Necessary?.Also, my blower motor started acting up and it turned out to be a combination of a few things. The power feed for the blower motor goes...
