G
gmbellew
Latest activity Postings About
-
-
Ggmbellew replied to the thread What have you done to your square lately??.maybe the ECM is bad? I don't think that is very common, but sounds like you covered a lot of bases already .... yeah, what Bucket...
-
Ggmbellew replied to the thread Getting to much fuel.also, to check base idle without IAC, you have to force IAC closed and then unplug it. or remove it and otherwise plug the passage.
-
Ggmbellew replied to the thread Getting to much fuel.I am also having a rich condition. but only at idle, in park with no accessory load. I think 9-13 psi is the spec fuel pressure range...
-
-
Ggmbellew replied to the thread Diagnostic Data Connector '87 R1500.there is OBD1 and OBD2. i forget the change over date, sometime in the mid 1990s. they are not the same and require different readers...
-
Ggmbellew replied to the thread k10 drag link steering question.either a raised steering arm or a drop pitman arm or both are needed to correct the drag link angle. like mentioned above, I've read bad...
-
Ggmbellew replied to the thread Sealing Windshield.the service manual shows urethane on the pinch weld before gasket is installed. and on the gasket where the glass sits. some sort of...
-
-
Ggmbellew replied to the thread How to send power to window switch for testing?.isn't the relay also getting power directly from the battery to power the window?
-
Ggmbellew replied to the thread How to send power to window switch for testing?.
-
-
Ggmbellew replied to the thread how to delete auto door locks.as far as I know, that is not an OEM feature. it is likely part of an aftermarket keyless entry system
-
Ggmbellew replied to the thread How to send power to window switch for testing?.pink is constant power with key on. ground always goes back through the master switch. power is switched between the other two wires to...
-
Ggmbellew replied to the thread How to send power to window switch for testing?.did you replace the wiring harnesses, or keep the OEM wires and just use their switches? it looked like their switches required their...
-
Ggmbellew replied to the thread How to send power to window switch for testing?.did you use their switches or keep the OEM switches?
-
Ggmbellew replied to the thread how to delete auto door locks.that is a feature of your remote entry system. you will need to follow the manufacturer directions.
-
Ggmbellew replied to the thread Newbie with electrical issue on my 85 Scottsdale that belonged to my dad.could be a burned up fusible link? isn't there one on the way to the starter?
-
Ggmbellew reacted to CalSgt's post in the thread Need a good rear gear for a LS swap. 308 to 323 worth it? with
Like.
Assuming the 4L70 has a .7 override like other 4 speed autos a 3.89:1 would put you closer to where you want to be RPM wise @ 75 MPH...
-
-
Loading…
-
Loading…
