Where can I get this bearing for my Automatic locking hub?

[Sad Sack]

Years back (if part numbers were not legible on the old bearing), I would just take all the bearing dimensions, type of bearing, etc. and grab a bearing manufacturers interchange book, you know the big thick dusty mofos that some auto parts stores will have in a book rack and proceed to the size section and start studying.

 

[hack_man]

Years back (if part numbers were not legible on the old bearing), I would just take all the bearing dimensions, type of bearing, etc. and grab a bearing manufacturers interchange book, you know the big thick dusty mofos that some auto parts stores will have in a book rack and proceed to the size section and start studying.

That sounds like my favorite way of doing it, the old paper way no internet needed. Something about a paper catalog that's just better.

 

[hack_man]

I use Bearing Headquarters,or IBT and have had 99 percent success rate with any oddball crap I've needed. IDK if they have these local to you.

Holy crow I was browsing their catalog and I found a $6,600 bearing

You must be registered for see images attach

 

[Ricko1966]

Holy crow I was browsing their catalog and I found a $6,600 bearing

You must be registered for see images attach

OMG unbelievable, I looked it up somewhere else 6,634.87 is a bargain LOL could be 8244.00

You must be registered for see images attach

 

[Ricko1966]

Holy crow I was browsing their catalog and I found a $6,600 bearing

You must be registered for see images attach

At $6600.00 it's probably cheaper to just buy new hubs,!!!

 

[vr1967]

I’ve got a few spare auto hubs for parts. Will dig them out and see what I have.

These are for the K10/K20 front ends? I have a set of NOS D60 auto hubs also

 

[hack_man]

Yes this is for a K10 1983. It's shown in This earlier post