Turn Signal Switch Repair

[87ChevyR10]

So, I bought a new switch to replace the old. Basically, the old one is split where the silver philips head screw goes on the far left near the lever. I was thinking that instead of pulling the column apart, I'd simply super glue the split so it stays together. Currently, I can get my right side signals to come on if I hold the lever up; however, the left side does not work. That split allows enough play to prevent the lever from working the switch correctly.

So, any suggestions on what glue to use?

Thanks!

 

[87ChevyR10]

Well, after trying to epoxy the break together, it still failed. So, I ended up replacing the switch. Wasn't too bad. I couldn't get the wire protector sleeve back into the column. But nonetheless, it's fixed.

 

[Old77]

@89Suburban did a YouTube vid on this repair