1984
-
F
Paint search
Hey everyone, I could use some help deciding on the right blue for my 1984 GMC Jimmy. It’s a two-tone setup, currently white with a light blue/greenish shade, but I’m planning to repaint it to white + a classic glossy blue. The tricky part is choosing the right blue. I’m aiming for something...- Faris
- Thread
- 1984 gmc jimmy two tone
- Replies: 20
- Forum: Paint and Body
-
T
Not using factory fuse box after engine swap, lighting wiring with column and ignition switch problems.
I have 84' C10 that is pretty much completely gutted inside and out, it has a Ls and 4l80e in it. Before this month it was wired awfully from the swap with a rat nest of unused wires hanging around under the dash. since its engine swapped and only has exterior lights, no blower radio dome light...- Trenholm
- Thread
- 1984 c10 engineswap lighting turnsignal wiring wiring
- Replies: 5
- Forum: Electrical & Audio
-
GMC Grill
Looking for a grill for the 1984 K2500 I am building. Restorable, NOS, is fine. Any help would be appreciated!- Streetdreamer
- Thread
- 1984 k2500 square body grill
- Replies: 50
- Forum: Introduction
-
H
Break Light Wiring for a 84 k5 350sb
Howdy y'all! I'm semi new to the world of squares. I don't know much about 'em, but I'm learning as I go. I still have lots to learn, especially with wiring. My sister bought an '84 K5 a few weeks ago and the drivers side tail/brake light ain't working to good. Hit a bump, it works, hit...- Howdy225
- Thread
- 1984 84 k5 bad ground brake lights k5 blazer need help new here squarebody wiring
- Replies: 10
- Forum: Introduction
-
G
Instrument Cluster Lights and Dome Light
First: I know that this topic has been discussed ad nauseam. I have read tons of threads with great troubleshooting advice, but I can’t seem to find a good solution to my problem. Second: Full disclosure, I know next to nothing about electrical troubleshooting, please be kind. I have a 1984...- grwindmill97
- Thread
- 1984 dash lights dome light gauge lights instrument cluster k10 lighting
- Replies: 11
- Forum: Gauge, Speedo & Instrumentation
-
C
Transmission identification help
I have a 3 speed manual on my 1984 C10. The bell housing is aluminum. But, the transmission and the extension housing are iron. Using a transmission identification guide https://documents.holley.com/techlibrary_manual.pdf I believe my transmission is a Saginaw 343, but my extension housing is a...- candyredc10
- Thread
- 1984 3-speed manual transmission
- Replies: 2
- Forum: Transmission & Transfer Case
-
I
1984 GMC 1500 Sierra, interrior passenger door handle sticking...
I have an 84 GMC Sierra. The passenger door handle has become difficult to open from the interior. When you pull the lever to open the door to exit, its extremely tight. In fact, you have to press the lever closed, as it does not retract. The exterior button on the door handle is fine. Any...
