Search results
-
N
Engine bay grounds
I'm going through my first rodeo of doing an engine/ trans swap on my 85 C10. I'm getting ready to hook up my a/c, main battery and cab to motor ground, the only catch is my new manifold, heads, and water pump are aluminum. So rookie question in bound. The battery ground that grounded to the...- New_Guy
- Thread
- Replies: 19
- Forum: Tech Discussion
-
N
3" drop spindles and rubbing solutions
I recently installed 3 inch drop spindles on my 85 c10 and of course the stock rally wheels rub. I have heard that you can trim the control arm, but I am not to fond of Cutting and trimming a high stress part. I am looking into Tubular control arms by classic performance parts thinking they will...- New_Guy
- Thread
- Replies: 7
- Forum: Suspension, Steering & Brakes
-
N
Lowering help
The bike only weighs 410 lbs Sent from my HTC 10 using Tapatalk- New_Guy
- Post #3
- Forum: Lowered & Street Systems
-
N
Lowering help
This will sound slightly idiotic, but I need some advice. I want to lower my truck, I was thinking about 4-5ish.... But my concern is how low can I go (on a budget so bags are out of the question) before I cant haul my motorcycle to the track? What I mean by that is; hitting the bump stops or...- New_Guy
- Thread
- Replies: 16
- Forum: Lowered & Street Systems
-
N
85 c10 square body no spark HELP!!!!
Thank you! Sent from my HTC 10 using Tapatalk- New_Guy
- Post #37
- Forum: Engine & Performance
-
N
85 c10 square body no spark HELP!!!!
The bottom of the distributor gets hot after about ten seconds of trying to turn the truck over, and at 30 seconds you can keep your hand on it it's so hot... Sent from my HTC 10 using Tapatalk- New_Guy
- Post #35
- Forum: Engine & Performance
-
N
85 c10 square body no spark HELP!!!!
I can find one with the esc plug and a vacuum I can only find them either or . Sent from my HTC 10 using Tapatalk- New_Guy
- Post #34
- Forum: Engine & Performance
-
N
85 c10 square body no spark HELP!!!!
Do you know where I could find such parts? Sent from my HTC 10 using Tapatalk- New_Guy
- Post #15
- Forum: Engine & Performance
-
N
85 c10 square body no spark HELP!!!!
I'll look into it, I'm almost tempted to replace the whole distributor with a msd brand one. Sent from my HTC 10 using Tapatalk- New_Guy
- Post #11
- Forum: Engine & Performance
-
N
85 c10 square body no spark HELP!!!!
If I remember correctly I did, but I'll double check to be sure. Sent from my HTC 10 using Tapatalk- New_Guy
- Post #10
- Forum: Engine & Performance
-
N
85 c10 square body no spark HELP!!!!
I did the test on that before I replaced the icm and that tested good but I didn't do it out of the truck. Sent from my HTC 10 using Tapatalk- New_Guy
- Post #9
- Forum: Engine & Performance
-
N
85 c10 square body no spark HELP!!!!
Yeah I do that's why I'm stumped.. Sent from my HTC 10 using Tapatalk- New_Guy
- Post #5
- Forum: Engine & Performance
-
N
85 c10 square body no spark HELP!!!!
Yes it does Sent from my HTC 10 using Tapatalk- New_Guy
- Post #4
- Forum: Engine & Performance
-
N
85 c10 square body no spark HELP!!!!
I just got the truck for my dad and we have absolutely 100% no spark I replaced the battery, coil, distributor cap, rotor, icm, plugs, and plug wires. Please help I'm at my whits end! Thank you in advance!! Sent from my HTC 10 using Tapatalk- New_Guy
- Thread
- Replies: 37
- Forum: Engine & Performance
-
N
Howdy from Colorado
My name is Shane So, I finally got the truck that's been in my family from new. My grandpa purchased from the show room, then my dad bought it from my grandad, and now I bought it from my dad. It's an 85 c10 silverado with the original **cough** 305. My grandpa put 3/73 gears in the rear end...- New_Guy
- Thread
- Replies: 7
- Forum: Introduction
