Search results

  1. Rockinpcranch

    90 k5 driveshaft length

    So I’ve got a 90 k5 with 241c transfer case and 700r4 I need to get a rear driveshaft built as the old one is missing. I’ve got a local driveshaft shop that can build it I just need measurements. I measured from the end of the output shaft on the transfer case to where the u joint sits in the...
  2. Rockinpcranch

    Target master 350 reseal or run

    Just picked up a target master 350. It has 10,000 documented miles but, has been sitting for 8 years since being pulled. a mechanic friend remembered he had it in the barn. When he stored it he put oil in the cylinders and plugged it off and wrapped it in plastic, as when he bought it after...
  3. Rockinpcranch

    Pinion bearings failed need help with specs

    I've got an 84 K 20 with a semi floating rear with 9.5 ring gear. The front pinion bearing failed. My Hanes manual says to take measurements and go back to the same spec. The problem with that is I didn't have a good spec to use. I'm putting all new bearings in the whole diff and I need help...
  4. Rockinpcranch

    Turbo 400 delayed shift

    I have an 84 K 20 4X4 with the 350 and a turbo400 and when you shift from park to reverse it takes a bit to shift and engage, it does the same going to drive from park or from reverse to drive. Is there a was to adjust this? I only see the shift linkage and a vacuum line going to the...
  5. Rockinpcranch

    will 285/75/16 fit on a K20

    So I got the 84 running and now it's time for tires. I Had some 265/75/16 from the last time I put tires on the Z-71 I put on the 84's rims. The 265s fit well but are close to racing slicks. I have got a coworker that is about to scrap a truck and offered me the 285's with about 75% tread off...
  6. Rockinpcranch

    New Okie with an 84 K20

    I'm Lance I'm from Claremore OK. I've got an 84 K20 That I bought from my buddies Dad he bought it in 06 my buddy got it in 07 and we ended up putting on a front clip after a tree jumped out in front of him. Then his brother got a hold of it and killed the original engine and put several...

Latest posts

Forum statistics

Threads
42,178
Posts
910,773
Members
33,674
Latest member
bennlenl
Top