Search results

  1. K

    454 spits out carb at 20% or so throttle at low speed

    Not sure of the guts of the edelbrock but I would start with 12 degrees on the timing and possible look at the intermediate circuit in the carb. Possibly move up a jet size if that is what is in it. Hope this helps.
  2. K

    06 4L60E swap into my 88 V10

    The original TBI system has a speed sensor in the speedometer but I am running an Edelbrock pro-flo so will have to see what the controller setup is when I get it. I had the bell housing up on the motor so I know that fits and am now measuring flywheel differences. looks like I will have to run...
  3. K

    06 4L60E swap into my 88 V10

    Has anyone here had any experience with installing a 4L60E 2piece trans into a 91 or earlier V10? I have a controller I just want to get more clear on the flywheel, torque converter, starter problems I may run into. The Trans is out of an 06 Avalanche. I am done with the TV system!
  4. K

    Steering column guru’s, where does this spring go??

    I go in there just to take that annoying key alarm out. Camp a lot and the keys stay in the ignition and I dont have to listen to it any more! Ha!
  5. K

    454 engine

    They be coming soon! Both my burbs now. It was the converter bolt by the way. Dont have to pull the big ass motor out!
  6. K

    454 engine

    2 WD but I have a complete 4WD drive train in my back yard... It may just find its way under this 3/4 ton. Will leave the 14 bolt in the rear.
  7. K

    454 engine

    Thanks to all. I can live with that. I did end up with the burb and will be making sure of the knocking noise before I go pulling the motor. I have had loose converter bolts fool me more than once! Best score of my life though on this body!
  8. K

    454 engine

    Greetings all, Anyone here have any knowledge about what MPG I could expect from an 88 Suburban with a 454? It only has 34,000 original miles but the guy that owns it did not change the oil enough and pulled a large camper trailer and it has a knock which I determined to be a rod for sure. I...
  9. K

    Fuel Pump Problem

    I would get the entire unit if you can. What would happen to me if it was my truck is the tank sending unit would go bad 3 months down the line. LOL
  10. K

    Help! High beams always on!

    Your column switch is adjustable. Sounds like it is out of adjustment. Just something to check.
  11. K

    urethane dash pads anyone?

    Bought one of those urethanes off Ebay and it was total crap. Did not fit, the metal clip inserts came out, bezel would not even go in. They advertised "made in USA" but it was total junk for 300.00. Even cost me 50.00 to send it back. Stripped all the plastic off the factory one and am looking...
  12. K

    bad shake in rear of truck from 55ish to 65 ish

    My experience is that when you have a drive line issue the frequency of the vibration in much faster than a wheel balance issue. In other words your driveshaft is making many more turns than your wheels are so it will be more of a fast vibration rather than a shake. Wheel balance issues are much...

Latest posts

Forum statistics

Threads
42,109
Posts
909,277
Members
33,595
Latest member
T3rraBeara
Top