Search results
-
T
LS Swap Throttle Cable Issues
I just bent the stock pedal assembly up a bit so that at rest it was putting a little tension on the cable. It doesn't take much.- TrybalRage
- Post #3
- Forum: Engine Swaps (Gas) LS, Vortec, LT1 , etc.
-
T
LS Swap AC Location
https://tejassteelworks.com/product/squarebody-ls-motor-mounts/ Note that this moves the motor up and forward. So your Exhaust, Driveshaft, Trans mount will all need to move/adjust as well.- TrybalRage
- Post #17
- Forum: Engine Swaps (Gas) LS, Vortec, LT1 , etc.
-
T
Cluster install for DUMMIES...help
When I hacked apart my cluster I sat down with the original and traced the lines on the flexible circuit board. On a piece of graph paper I drew a rectangular box representing the electrical connector and labeled each square according to where the line went (temp / oil press / L turn / R turn /...- TrybalRage
- Post #21
- Forum: Electrical & Audio
-
T
Dual tank on a short bed
I'm in the middle of tearing my system out... I have a LWB with dual 16 gallon tanks and I'm going with a single 20 gallon. You'll need: Tank (same tank # as drivers side) Passenger side sending unit Straps/bolts/hardware Fill and vent tubing, along with the filler neck with flap Fuel tank...- TrybalRage
- Post #7
- Forum: Exterior
-
T
i blew up my SBC 350...thinking LS
I've been researching quite a bit on what you'll need for an LS swap, since I'm considering the same for my 85 C10. Yes, you'll need custom motor mounts (~$100), headers or manifolds, a custom or modified wiring harness ($500+ to have someone do it), and a new tank and fuel pump. The PCM will...- TrybalRage
- Post #9
- Forum: Engine Swaps (Gas) LS, Vortec, LT1 , etc.
