Search results
-
-
crate engine or rebuild original 350?
look on jegs website they have a engine as low as 1500 for you truck http://www.jegs.com/p/Chevrolet-Performance/GM-Goodwrench-350ci-260HP-Engine-Packages/752506/10002/-1 buy the time you buy parts to rebuild, machine shop, labor your price will be up there and then down time between all that...- muddyman184
- Post #6
- Forum: Engine & Performance
-
front bumper??
I like diy's if my truck was sitting up high but the rlc one is nice and simple- muddyman184
- Post #5
- Forum: Exterior
-
Installed lift kit but front lower
Just like 8T6KS said OFFROAD DESIGN or DIY4X has the zero rate add a leafs go to their website and check it out- muddyman184
- Post #8
- Forum: Lifted & Off-Road Systems
-
-
-
-
-
-
Hello from Pa
yea that junk 150 isnt mine its my buddies (which he hates) but hey it was free so- muddyman184
- Post #17
- Forum: Introduction
-
Hello from Pa
if im not mistaken it is a 07 but that bike is long gone- muddyman184
- Post #13
- Forum: Introduction
-
Diesel MPG
oops just realized this thread was old o well- muddyman184
- Post #21
- Forum: Diesel 6.2, Conversions Cummins, etc.
-
Hello from Pa
It was a R6 and trust me my buddy wished it was a R1 and thanks its hard trying to fix up 2 trucks at the same haha- muddyman184
- Post #11
- Forum: Introduction
-
Diesel MPG
01 to 04 were LB7s 05 was LLY and 06 was LBZ then 07 to 10 were LMM 05 and 06 were one year model engines i read it in my diesel power magazine i drive my uncles 08 dmax crew cab 4x4 and it has alot of power and torque i would love to get one but when stuff breaks it gets $$$- muddyman184
- Post #20
- Forum: Diesel 6.2, Conversions Cummins, etc.
-
custom dash questions
I loved how that turned out im going to have to try that on mine, so you used contact cement to mount the foam on the metal and then used it again to mount the vinyl to the foam?- muddyman184
- Post #13
- Forum: Interior
-
Hello from Pa
[/IMG] and another one you can see nothing lines up and the rear end isn't sitting higher it is from the dump set up brackets being on top of the frame- muddyman184
- Post #4
- Forum: Introduction
-
Hello from Pa
bed is all beat up dented whoever put the pump set up on was a bad welder and nothing lines up and the dump set up dosent work any more id rather build a wooden flat bed with some removable sides seems more practical to me and how i use it [/IMG]- muddyman184
- Post #3
- Forum: Introduction
-
Hello from Pa
Hi everyone i been on this browsing this site for about a year now and finally just joined i have a lifted 1990 k5 blazer that my buddy installed a 4" lift on and repaired a few rust spots on the floor and i also have a 1982 k20 that has a dump setup on with a stock bed onit so it has that...- muddyman184
- Thread
- Replies: 16
- Forum: Introduction
