Control Arm Bushing Installation

Ronno6 · Jan 22, 2020

I took a 1x4 piece of red oak cut to length to fit between the outer flange, then cut 2 grooves across the face in the locations of the inner webs. In so doing, I held each channel open as well as maintained the overall width.......

Rusty Nail · Jan 22, 2020

After all that there's still no pix.

:yawn:

Ronno6 · Jan 22, 2020

You must be registered for see images

Rusty Nail said:
After all that there's still no pix.

Imagine a 1x4 about 18" ling with a groove cut across it 1 1/2" in from each end...........

Ronno6 · Jan 23, 2020

For Rusty:
Pic1. Basic layout

Pic2 another look

Pic3 brace in position

You must be registered for see images attach

Rusty Nail · Jan 23, 2020

Very nice. I bet that feels good! Not only completing the repair, but lots of readers are looking for tips or tricks to do similar projects to similar trucks and the pictures can really help. Damned if we ain't all in it together!

That's been my experience and we certainly welcome YOUR experience, glad to have ya @Ronno6 . Thanks for postin the Pix.

:waytogo:

Ronno6 · Jan 23, 2020

Rusty Nail said:
Very nice. I bet that feels good! Not only completing the repair, but lots of readers are looking for tips or tricks to do similar projects to similar trucks and the pictures can really help. Damned if we ain't all in it together!

The thought had occurred to me.............hence the pix.

Control Arm Bushing Installation

Ronno6

Full Access Member

Rusty Nail

Full Access Member

Ronno6

Full Access Member

Ronno6

Full Access Member

Rusty Nail

Full Access Member

Ronno6

Full Access Member

Similar threads

Latest posts

Forum statistics