Ronno6
Reaction score
115

Latest activity Postings About

    • Ronno6
      Ronno6 replied to the thread 84 C10 Gas Tank Refurb.
      I guess these guys just don't know... http://forum.73-87chevytrucks.com/smforum/index.php?topic=35133.0
    • Ronno6
      Ronno6 replied to the thread 84 C10 Gas Tank Refurb.
      BTW...I had read somewhere that the fuel line sizes are: Fuel line............3/8" Return line........5/16" Vent..................1/4"...
    • Ronno6
      Ronno6 replied to the thread 84 C10 Gas Tank Refurb.
      Well, NO tefurb to be done here.........REPLACE !! The RH tank had apparently been replaced B-4. There was junk yard grease pen marking...
    • Ronno6
      Ronno6 replied to the thread Dual Tank Valve Ground.
      You are correct. I was able to see +12v at the harness when the switch was pressed up, then -12v when pushed down. But, then the voltage...
    • Ronno6
      Ronno6 replied to the thread Dual Tank Valve Ground.
      Be that the case, then for one tank, one green wire is 12v + and the other is ground, then they swap for the other tank position of the...
    • Ronno6
      Seems like a simple question: 1984 C-10 gas engine. How is the dual tank switching valve grounded?? Only thing I can see is that the...
    • Ronno6
      Ronno6 replied to the thread 84 C10 Gas Tank Refurb.
      The show so far. Passenger side tank is first. I disconnected the fuel supply, return and vent hoses from the tank. Well, cut them...
    • Ronno6
      I have the bed off my '84 C10. I need to R&R my gas tanks. Is there a recommended procedure for this? Do the tanks drop down before...
    • Ronno6
      Ronno6 replied to the thread wood dimentions.
      Measure the spacing of the holes in the cross braces.....that should give you some idea.
    • Ronno6
      Ronno6 replied to the thread wood dimentions.
      5/4 will typically be about 1" thick, but you really need 7-1/4" wide finished dimension or you will need an additional metal strip and...
    • Ronno6
      Ronno6 replied to the thread Maple For Truck Bed.
      I have been told that what you described is actually quarter-sawn........so confused.....
    • Ronno6
      Ronno6 replied to the thread wood dimentions.
      There should be 7 boards, and the total width is 50" under the side angles. That would make it 3/4" X 7-1/4" X 78" in length....I...
    • Ronno6
      Ronno6 replied to the thread Maple For Truck Bed.
      Is there a preference for quarter sawn vs. riff sawn?
  • Loading…
  • Loading…

Latest posts

Forum statistics

Threads
37,489
Posts
802,668
Members
27,491
Latest member
grimm106
Top