Turbo4whl's latest activity
-
Turbo4whl replied to the thread Oil pressure sensor?.Between 1/4" and 3/8" is 5/16". Get a piece 5/16" key stock. Grainger, NAPA and others have it. Hacksaw a piece off and use a 12... -
-
Turbo4whl replied to the thread Behind seat.That space is where your sub-woofer goes. One 12" duo voice coil speaker. Air space is correct. Pulled it out to swap the speaker...
-
-
Yes, my Chevelle does great with r134a. That POA valve does a great job of keeping the air out the vents at 33° too.
-
Turbo4whl replied to the thread 1979 454 C10, Factory Air.Early Squares had a Fridgeaire pump and a POA valve. They did not use a recycling pump clutch, when you turned it on the pump was always...
-
-
Turbo4whl reacted to Bennyt's post in the thread 1984 Winnebego RV P30 Chassis 454 Th475 and REAR DISK BRAKES. with
Haha.
i totally understand. Ive had to unstick a few. I just wouldn't trust a hydraulic parking brake as pressure bleeds off eventually. And... -
Turbo4whl reacted to WFarm's post in the thread What have you done to your square lately?? with Love.
Gorgeous day, went for a great drive. I had also driven it to town yesterday so before today’s drive I checked bolt torques on the...
-
Turbo4whl reacted to Ricko1966's post in the thread Oil pressure switch adapter or relocation with Like.
The switch is a redundant power supply for the fuel pump,so if the relay dies the pump still gets power through an oil pressure switch...
-
Turbo4whl replied to the thread Hydroboost.Confirmed! My GMT400 3500HD twin winch NoMar wrecker. I added the auto-loader on the 6000 lb. wheel lift. This was also the...
-
-
Yes all square one tons are front discs/rear drums. All GMT400's are too except for the 3500HD which are definitely a different animal...
-
Turbo4whl reacted to Squarescare's post in the thread Oil pressure switch adapter or relocation with Like.
Changed it I was wrong both ports were used the one behind the distributor was an oil pressure SWITCH and the one on oil filter the...
-
Turbo4whl replied to the thread What have you done to your square lately??.To make that C65 fuel gauge work correctly, remove the resistor bolted to the back of the gauge, replace it with the resistor from your...
-
Fusible links are always 4 awg sizes smaller than the wire it protects. When I switched to a larger gauge charge wire for my...
-
Turbo4whl replied to the thread Oil pressure switch adapter or relocation.If you are running wires to a switch by the oil filter, make sure you cover them with a heat shield covering. Wires near the exhaust...
-
Turbo4whl reacted to Squarescare's post in the thread Oil pressure switch adapter or relocation with Like.
Thanks to both of ya that's what I wanted to know, and I didn't know there was a port down at oil filter. My factory switch is behind...
