Recent content by RKBMKZ
-
Pollack Tank Selector Valve
If you lived in Spokane, I'd be driving a beer over to your house right now. Tried the toggle, the other pump just whined. Switched the power wire to the different pump; same thing. Changed the plug cable from D to E and E to D - no whine and just went for a 6-7 mile drive with no change in...- RKBMKZ
- Post #9
- Forum: Engine Swaps (Gas) LS, Vortec, LT1 , etc.
-
Pollack Tank Selector Valve
That actually makes sense. It's opening up the valve but running the opposite pump. I think I can just switch it at the toggle. We'll see. Thanks.- RKBMKZ
- Post #8
- Forum: Engine Swaps (Gas) LS, Vortec, LT1 , etc.
-
Pollack Tank Selector Valve
Could there be a bad ground on the squeeling pump? I've had one tank down, but not the other. Doesn't seem the pump would work.- RKBMKZ
- Post #5
- Forum: Engine Swaps (Gas) LS, Vortec, LT1 , etc.
-
Pollack Tank Selector Valve
There is one extra port on the plug, but there is nothing coming from it. Could that be where I supply power?- RKBMKZ
- Post #4
- Forum: Engine Swaps (Gas) LS, Vortec, LT1 , etc.
-
Pollack Tank Selector Valve
I followed things to the T. Do you remember where the wiring was wrong? Maybe I'm an idiot. I've got two wires to each of the wires on the plug; one to the power and the other split to the pump. I even put a completely new wire to one so there was no question.- RKBMKZ
- Post #3
- Forum: Engine Swaps (Gas) LS, Vortec, LT1 , etc.
-
Pollack Tank Selector Valve
Hello all, just got my '77 K10 back from a 5.3 install, but having trouble with the selector valve. Got two brand new tanks from Tanks inc or PSI Conversions with Walboro internal pumps. The guy who installed it said the system runs between 58-62 psi and had a gauge on it to confirm. Just...- RKBMKZ
- Thread
- pollack selector twin tanks vortec
- Replies: 11
- Forum: Engine Swaps (Gas) LS, Vortec, LT1 , etc.
