Rich77's latest activity
-
I used these hangers from Summit if you’re willing to weld, I couldn’t find any good pictures of how the rear mounts are bolted up. -
Rich77 replied to the thread Bolt pattern adapter.Thank you for the reply!
-
Of course there are downsides to using them,and risks. It is one more possible point of failure, some states they aren't even legal. If...
-
Rich77 replied to the thread Exhaust pipe bracket.I actually need both. My truck was single pipe but the brackets were rotted.
-
Hello, Have any of used bolt pattern adapters? How do they hold up? Are there downsides to using them? I want 17x8 up front. That’s...
-
I’m currently building my 85 c10 longing bed. I have a set of 15x7 slots. That I want to run. But I can’t figure out what tire to run...
-
Hello All, Regarding the bracket that bolts to the inside of the frame- For those of you who have gone from single to dual exhaust or...
-
Contrary to the older belief, you do not need back pressure for an engine to run. You may need to make adjustments to timing and the...
-
Run a fused hot wire to coil from battery. See if it stays running
-
I had a suburban that was acting kind of similar and it was driving me nuts. I had the distributor cap off and would crank the motor and...
-
Remove #1spark plug. Tightly stuff a shop rag into plug hole. Tightly! Bump starter over with key till you hear it pop out the rag and...
-
If it is backfiring out of the carb, you are 180 out. It was trying to fire before and not backfiring, so you just needed to turn it a...
