Recent content by malibuman402
-
1977 K10 9j9 sport deluxe stepside with factory tach and roll bar.
welcome, I have an 84 c10 with a factory installed np833 4 speed trans. very hard to find. but I built a bb 427 for it and it is a blast to drive. she's a keeper.- malibuman402
- Post #10
- Forum: Introduction
-
-
-
350 and 4 speed manual removal
don't remove the hood. remove the core support and the bumper, that's how I have done it. remove the grill, headlight bezels and wire harness from the core support, then the core support, loosen the 2 bolts on the backside of each fender well and the 1 bolt on top of the fender by the hinge...- malibuman402
- Post #5
- Forum: Tech Discussion
-
New Badges for Military Service Members, LEO, FireFighters and EMT
US Navy, please. 1974-1983. thanks.- malibuman402
- Post #27
- Forum: Site News
-
-
-
Hello from Dallas
Welcome from NC. if its a NP833 with a hurst shifter it is rare. no production numbers are available. RPO code MM7 or MY6. my 84 C10 has one, RPO code MM7. it has close to the same gear ratios as a 700R4. 4th gear is a .73 OD.- malibuman402
- Post #13
- Forum: Introduction
-
Alcohol and Ebay don't mix....
welcome from North Carolina- malibuman402
- Post #18
- Forum: Introduction
-
Who Sells The Best Wiring For Electric Windows and Locks
lmc truck has a window wiring harness.- malibuman402
- Post #14
- Forum: Interior
-
-
-
BBC swap in my k20
i did a small block to big block swap and used the small block mounts, fits good. just bolted the small block mounts to the big block and put the motor in.- malibuman402
- Post #14
- Forum: Tech Discussion
-
454 Timing
I would suggest 8-12 degrees BTDC with the vacume advance disconnected. then reconnect and take it for a ride.- malibuman402
- Post #9
- Forum: Engine & Performance
