Recent content by john55
-
J
small hole in oil pan
I replaced the pan and filter .it needed changed 230k. it was a easy fix thanks again everyone- john55
- Post #10
- Forum: Tech Discussion
-
J
Squarebody Down! HELP - Member Roadside Assistance Volunteer Map
Put me down I have tools what we cant fix a couple local places can reasonable for example had trouble bleeding brakes , shop 2 guys over a hr breaking zerks loose bled breaks master cylinder etc $35 -
J
small hole in oil pan
Chengny , your right a new trans pan is cheaper than I thought. Looks like about dozen bolts appears a easy fix. The car is safely off the road in parking area. I thought first it was the oil pan , on a saturn more work . On a good note im driving my c20 more. Thanks everyone- john55
- Post #8
- Forum: Tech Discussion
-
J
small hole in oil pan
It ended up being trans pan. Im going to try the ideas for a temporary patch thanks.- john55
- Post #6
- Forum: Tech Discussion
-
J
small hole in oil pan
I didnt see a concrete vehicle stop In front of my saturn when I parked I drove forward went up on it , I backed off it , noticed hole in oil pan . I was wondering will jb weld work on it as a temp fix to get it home 17 miles. Its ok sitting there I just dont want to work on it there. Thanks...- john55
- Thread
- Replies: 9
- Forum: Tech Discussion
-
J
which floor jack?
If this is doubke post please over look. I need to buy a new floor jack the will lift my c20 mainly flat tire etc. What capacity should I buy? And is the harbor freight ones ok? Thanks in advance -
J
What have you done to your square lately??
Replaced the starter with one with new lifetime warranty. Make a big difference. Turns over fast. -
J
What have you done to your square lately??
HCPC you are right on target, cast intake and Qjet. i think i will get the high torque starter thanks for your advice john -
J
What have you done to your square lately??
mechanic said the c20 was out of time, he set timing truck runs great a lot of power. i shut it off wouldn't start cooled off started hard, never been a problem. i talked with the mechanic,said he had to advance timing to get it to run well ,said to pump the gas pedal to get cooler gas? he... -
J
What have you done to your square lately??
replaced the air filter and the pcv valve -
J
What have you done to your square lately??
Hrpc, i know what you mean about neck & back pain, i take morphine 3 times a day. i can't take over the counter( stomach issues)have you tried a inversion table ? it helps me. -
J
What have you done to your square lately??
Sorry HCpc . i didn't see it either. but i wouldn't be any help. good luck -
J
What have you done to your square lately??
replace back-up light in utility bed. had brakes bled. still has some air, try again wed. need to replace plug wires. question... quadrajet carb issues. should i have it rebuilt ? or replace it with a edelbrock? thanks in advance john -
J
What have you done to your square lately??
i changed fuel filter on the q jet easy enough. then started changing plugs looked easy, plenty of room to work . the heat shields were all bent up. difficult to get the socket on /off plugs. the plug wires were stuck on even with wire puller one end came off. harder than i expected lol
