Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
Registered members
Current visitors
Menu
Log in
Register
Install the app
Install
Members
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
edgephoto's latest activity
E
edgephoto
replied to the thread
Dual Battery
.
Is the effort worth it? Just make sure your alternator is big enough and the alternator and battery cables can handle the loads.
Apr 24, 2025
E
edgephoto
replied to the thread
Do I restore my AC or?
.
My 1981 Pontiac Grand Prix had an R4 compressor. GM was using them at that time, at least in the A bodies.
Apr 24, 2025
E
edgephoto
reacted to
Ricko1966's post
in the thread
Do I restore my AC or?
with
Like
.
I use 80 percent charge then sneak up on it,monitoring,duct temp and system pressures.
Apr 24, 2025
E
edgephoto
replied to the thread
Do I restore my AC or?
.
That would be an expensive and time consuming proposition. I might consider this if I were building a daily driver but I am building an...
Apr 24, 2025
E
edgephoto
replied to the thread
Cracked TH350 case
.
TH350s are pretty common. Why screw around with trying to get it fixed? Just buy a rebuilt unit or a used one that needs a rebuild and...
Apr 23, 2025
E
edgephoto
replied to the thread
Dual Battery
.
You can wire them in parallel. Hook the two positives together and the two negatives together. You could also use a battery isolator to...
Apr 23, 2025
E
edgephoto
replied to the thread
Pretty sure I blew a head gasket this morning....
.
Do you have a cooling system pressure tester?
Apr 23, 2025
E
edgephoto
replied to the thread
Body repair panels
.
My NOS rocker and door needed the same amount of massaging that the repro rocker for the other side needed. These are mass produce...
Apr 22, 2025
E
edgephoto
replied to the thread
1987 Chevy V10 steering wander
.
In my experience, I found that about 15-20% of techs are excellent at their jobs. The rest fall somewhere in the realm of mediocre to...
Apr 21, 2025
E
edgephoto
replied to the thread
Starter won't dis-engage when key is turned off.
.
Yes, you are correct, it is Watts law. To get the same Power(Watts), if the voltage drops you need to increase the Amps. I was not...
Apr 21, 2025
E
edgephoto
replied to the thread
Replacement mirror heads and elbows?
.
That mirror "elbow" might be an aftermarket or from a painted mirror. The GM ones were stainless. Just twist that bolt head off and...
Apr 21, 2025
E
edgephoto
replied to the thread
Starter won't dis-engage when key is turned off.
.
You said you replaced the lock cylinder. I would look at your ignition switch adjustment before I did anything else. The switch is at...
Apr 21, 2025
E
edgephoto
replied to the thread
1987 Chevy V10 steering wander
.
Don't even get me started with "It's in the green". I don't know how many times I have had to get involved with a case where the...
Apr 20, 2025
E
edgephoto
replied to the thread
New Guy
.
I forgot to say welcome to the forum.
Apr 20, 2025
E
edgephoto
replied to the thread
1987 Chevy V10 steering wander
.
Any good alignment will include a print of before and after. If you went to a tire store you probably only got the toe set/checked. Is...
Apr 20, 2025
Latest posts
Wanting to add factory power locks
Latest: Finkaire
47 minutes ago
Retro-Fit & Aftermarket Accessories
What have you done to your square lately??
Latest: bucket
Today at 12:22 AM
Garage
Fun Stuff (Statute of Limitations Has Run)
Latest: Turbo4whl
Today at 12:05 AM
Transmission & Transfer Case
Steering Wheel Too Close '84 C-10
Latest: Oldbear42
Yesterday at 11:55 PM
Interior
Distributor Wiring
Latest: Sad Sack
Yesterday at 11:47 PM
Tech Discussion
Forum statistics
Threads
45,947
Posts
996,618
Members
39,141
Latest member
jbwhitford
Members
Top