Recent content by dcfd470

  1. D

    1987 R10 Lowering question

    I still may put new uncut springs on next 1-2 inches only. Thanks Bill
  2. D

    1987 R10 Lowering question

    Thanks for the help I put 3 inch lowering spring on the front with the 2.5 spindles and that was way to low. I took the springs that I cut and I heated up and bent the bottom of the spring to make it sit better and I think this worked it looks good and rides ok. I am going to change out the...
  3. D

    1987 R10 Lowering question

    Hi thanks for the reply I am going over the list that you gave me. The control arm bushings are older and may need replacing which I am going to do but today I drove it home from work and I payed more attention to the vibrations. It seems to start at any time and after I hit a small bump in the...
  4. D

    1987 R10 Lowering question

    I have a 1987 Chevy truck r-10 2wd that I have restored from ground up and I now have a small problem with the lowering of the truck. The truck was all original and in very good shape when I started I just wanted to make a couple of small changes and lower it a little bit. I have been told...
  5. D

    1987 No Start No Fuel.

    Yes I am sure because when I hook power to the test lead on the relay you can hear it and that is the only time.
  6. D

    1987 No Start No Fuel.

    The engine light is good it has no power. As for another fuse that would explain it but I haven't seen it or remember seeing one. There is one more fusible link on the firewall from a terminal block I haven't change that one yet. Both sides of the block has power one of the wires is going to the...
  7. D

    1987 No Start No Fuel.

    I am working on a 1987 chevy 2wd short bed with a 350 in it. I had it running just fine and about a week ago I picked it up from the paint shop it sat for about 3 months and now it will not start. I have tried about everything that I know and I could find on the net and it still does nothing. It...
  8. D

    1987 c10 not starting

    Spark plugs look ok and I will have to check on the spray pattern I know there is gas going through the injectors but I don't know if it has a spray or it is just dripping I will look in the morning. Thanks Bill
  9. D

    1987 c10 not starting

    What do you mean? Thanks Bill
  10. D

    1987 c10 not starting

    Would the module make not fire at all but give me spark at the plug? Thanks Bill
  11. D

    1987 c10 not starting

    What do you mean? Thanks Bill
  12. D

    1987 c10 not starting

    Sorry about that Yes I am getting fuel.
  13. D

    1987 c10 not starting

    Hi thanks for the site this is my first post. I have a 1987 C10 with a 350 and I just took the engine out to clean and paint it and the engine compartment before it goes to paint. It was running fine when I removed it and I had it running after I put it back in. I was setting the timing and I...
See more

Latest posts

Forum statistics

Threads
42,322
Posts
913,641
Members
33,820
Latest member
tweeter68
Top