-
-
ASPEC replied to the thread I think a rod spun a bearing in my rebuilt 454.If the machine shop left those out then definately get your money and walk away, no excuse for that. Although, it might be fun to hear... -
ASPEC replied to the thread E-brake sticking after rebuild.You re-used the shoes... what repair were you performing?
-
ASPEC replied to the thread dies at low idle speeds, when put into gear and when stopped..Alot of the advise and direction we can give you is going to depend on your skill level... do you have any experience working on...
-
ASPEC replied to the thread Nylon cam gear years.Here is some info from Hayden: All fan clutches are for specific applications and should be applied only on the vehicle for which they...
-
ASPEC replied to the thread REDS NECK REPARES!~.The only acceptable band-aid is to replace the shoes with a cheap set. They can be had for under $40 (probably under $20 if you dig hard...
-
ASPEC replied to the thread Nylon cam gear years.Make sure when using a heavy duty or severe duty fan clutch that your fan is compatible. If your fan is has less than a 3" blade or not...
-
ASPEC replied to the thread 14 bolt brake cleanup.Yup, good stuff indeed. :)
-
ASPEC replied to the thread Nylon cam gear years.Hayden 2797 severe duty. I will post an update as soon as it has enough in service time.
-
ASPEC replied to the thread REDS NECK REPARES!~.I think the OP is bored and was attempting to make fun of a large part of the community. This was not their first attemp at using humor...
-
ASPEC replied to the thread Nylon cam gear years.The one on the left is the original... looks just like the 1974 service manual photo. The one on the right is what I replaced it with...
-
-
-
ASPEC replied to the thread Nylon cam gear years.Well, pulled the timing cover and found the timing set had been replaced sometime in the past with a cheapy standard melling kit and it...
-
-
ASPEC replied to the thread 14 bolt brake cleanup.If I had to guess, that axle has backed more than one boat down into some salt water...
-
ASPEC replied to the thread 14 bolt brake cleanup.Oh, and only tear down one side at a time...
-
ASPEC replied to the thread 14 bolt brake cleanup.Remove everything. Use a wire wheel on the backing plate, paint it with whatever engine enamel your local stores sell (I like Duplicolor...
-
-
-
Loading…
-
Loading…
