It’s definitely a broken piece and I’m not sure what either bolts into the front or some dowel pin goes into the bottom. I haven’t seen any assembled engines that use either the treaded hole or the opening on the bottom though so I’m not sure. I’m familiar with mostly building modular ford engines.
Hey guys! I bought a 383 block a few years ago and I’m finally ready to start building it. Upon further inspection I noticed a broke piece in a hole that is underneath where the mechanical fuel pump goes. What is the circled pieces function (1st pic with orange block) and if there is a whole...
I know what you are saying, and I agree. It went from a small rebuild/upgrade to a full on $6-7K build real fast. I was hoping to slowly get into this paying a little at a time.
Thanks for the feedback!
Good Morning everybody!
I am looking at getting a cam for my completely stock 350 engine in my 1978 Chevy C10 Big Ten truck. I want something that will work now, but also work with my future 383 built stroker engine with Edelbrock E-Street Cylinder Heads 5089 and Edelbrock Performer EPS...
New guy here.....been a mustang and jeep guy my whole life. I just inherited my grandfathers 1978 big10. It has been very well taken care of and lots of memories from my childhood. I am in shock and awe that he gave this to me.
I love to modify vehicles...my wife says it's an addiction! I...