-
-
SI had to replace the governor gear recently and now I’m getting a leak from the governor cover. It appears to be fully seated. I used...
-
SAre you sure the parking pawl is disengaging.Put the drive shaft back in the transmission and try to rock it clockwise counter...
-
SFrom my experience with automatics, all you can do is fill it up with fluid and see if it works. If it doesn't work - pull it out...
-
SDid you run the transmission selector lever through it's range of motion? Slime in the pan is not keeping the parking pawl engaged.
-
Sspedigo replied to the thread TH350 Stuck.the pawl was engaging when i cycled the rod. little spring on pawl was intact and everything on the shift shaft seemed to be tight and...
-
SWith the engine off, the vehicle should roll in all gears except park. How about starting the engine, and seeing if the transmission...
-
Sspedigo replied to the thread TH350 Stuck.dropped the pan today and it was just filled with fine shiny sludge. And I had just put in a new trans filter and fresh ATF. The ATF is...
-
-
Sspedigo replied to the thread TH350 Stuck.One thing I’m wondering, is if the S clip that connects the rooster comb to the valve came loose, or if for any other reason that shift...
-
Sspedigo replied to the thread TH350 Stuck.thanks. I’ll check that first thing on Saturday.
-
SIf it goes through the motions in the transmission linkage. Verify it take the linkage off and manually go through the first 3...
-
Sspedigo replied to the thread TH350 Stuck.I know it’s connected on the lower end at the frame. I just assumed it was connected well on the column because it is moving the linkage...
-
Sneed some ideas on what to check. Last Saturday did the first start on a new engine. Afterwards went to drop it in neutral and push it...
-
Sspedigo replied to the thread edelbrock fuel line leak. Anyone else?.anybody know the exact size of those particular crush washers? (Shop my truck is in is out in the country. Kind of need to have all my...
-
Sspedigo replied to the thread 1986 sbc th350 ran dry on ATF :o.hey Nick, I may have kind of similar problem. Just put in new engine and while it was out, I drained the transmission put in a new...
-
SWith a banjo, try to find softer washers. Brass, aluminum or what ever is the easiest to deform under pressure. Then all you can do is...
-
-
Loading…
-
Loading…
