xm20k
Latest activity Postings About
-
-
xm20k replied to the thread Truck runs very very rough.Fuel filters clean? Q jet has a small cartridge style filter in the inlet at the carburetor. Before you bought it did it sit for a... -
xm20k replied to the thread Engine oil capacity.SBC 1955-1979 dipstick located on driver side. 1980-1981 on either side with opposite hole plugged. 1982-up dipstick located on...
-
xm20k replied to the thread Body and frame welding needed.Think I would plate it inside on the back side of the hanger, on the top outside, on the bottom outside, and then box the rail about...
-
OBS = GMT400 The GMT400 immediately followed the squares. GMT800 started in 1999 model year. K
-
xm20k replied to the thread High Oil Pressure and Leaking After Oil Change.Fresh oil being thicker than old broken-down oil makes more pressure which in turn makes a leak more prominent. Find and fix oil leak...
-
xm20k replied to the thread Spindle issues.If you're asking OP I doubt his 84 is manual brake. If you're asking me. the spindles I have are 2" CPP drop spindles from a 78 big ten...
-
xm20k replied to the thread Spindle issues.Unfortunately I only have a set of 2" drop spindles with the heavier rotors on them.
-
Yea me either,personally I'd screw the stop in finger tight run it clockwise tell it stops,loosen the stop and turn it clockwise 10 more...
-
xm20k replied to the thread Is this a square body?.73-87 Chevy/GMC C/K trucks in 1/2 3/4 and 1 ton flavors were called the "Rounded Line" by GM due to their rounded cab but everybody...
-
xm20k replied to the thread Body and frame welding needed.Maybe they cut the rear off because they had some sort of hitch, or something welded into the rear they wanted to keep and couldn't just...
-
xm20k replied to the thread Gauge Cluster Question.I haven't used their speedo but have used their electrical gauges oil, temp, fuel and as long as the circuit board and housing they plug...
-
xm20k replied to the thread Oil pressure sender stuck..Didn't even think about low vis from dust/sand or high vibration situations like that, makes sense.
-
xm20k replied to the thread Rotate 350 «backwards».In my case 6, But I'd still rather not crawl under it if I can help it.
-
You will almost never use a flywheel wrench once you figure out that you can put a wrench on a converter bolt and pull the engine over...
-
xm20k replied to the thread Oil pressure sender stuck..They have AN line kits in various lengths now much nicer than even the brass line. https://www.summitracing.com/parts/sum-g2961
-
-
Loading…
-
Loading…
