legend57
Latest activity Postings About
-
-
legend57 replied to the thread 1977 K20 Heavy Duty Emissions.Hey Johnny. Congratulations on the K20. I got my '76 K20 about 3 years ago and have been going through restoration. I'm in the same... -
legend57 reacted to TCulpepper's post in the thread All time 4x4 / NP203 Truck Questions, hard to make tight turns with
Like.
Yes, the light indicator appears on the dash, I believe that was introduced in 1976. -
legend57 replied to the thread All time 4x4 / NP203 Truck Questions, hard to make tight turns.Interestingly, my shifter has a provision for a switch, but nothing was installed. Maybe an option(?). I can't say for sure my shifter...
-
legend57 replied to the thread All time 4x4 / NP203 Truck Questions, hard to make tight turns.Before doing any major swaps, I'd encourage you to go through the shifter mechanism. I believe the NP203 gets a bad rap (at least...
-
Anyone willing to take some measurements of their side trim? The top row is pretty easy because it follows the body line. The lower...
-
Started with some vacuuming and some compressed air and made sure I was starting clean again. Slid in the camshaft, then put the upper...
-
Yep, it was all taken apart. All new plugs throughout. He was going to just put new press in plugs in the front, but I told him that I...
-
legend57 replied to the thread Engine Build.I've used the Powermaster (#9612) starter for many years. Very reliable and have adjustable clocking for header clearance. Their...
-
legend57 replied to the thread Chuck’s engine build thread!.Did the machine shop remove the threaded plugs in the back of the block near the cam journal before hot tanking? If not, it may be...
-
legend57 replied to the thread 87' 350 SBC Rebuild.In '87, the bottom end was good and stout with the 4-bolt caps. The top end was terrible, mostly for smog reasons and economy. The...
-
-
Loading…
-
Loading…
