Goldie Driver
Latest activity Postings About
-
-
Got the chunk! You can see my totally-foreseeable-fail on that top stud. Yep, we all knew it haha. Carb is coming off in the winter... -
Do you have a welder or access to one. Oxyaccetelyn or Mapp gas torch? If you have access to a welder put a flat washer over the broken...
-
Small propane torch and heat the stud? Obviously not right afer you apply the kroil but... id just throw a cheap block off plate on it...
-
Goldie Driver replied to the thread Done dun it.Well, all you will need is a block off plate and a gasket and to plug the 1 vacuum hose that feeds it. Id say try it and see if your...
-
I finally got it installed and it works and functions as expected, the same as back in the day. It is comfortable and presents a...
-
Goldie Driver reacted to DoubleDingo's post in the thread Stolen truck found after 30 years with
Like.
This is partly why I don't want to sell my '81 C20, it has all the factory equipment, which is minimal, and it's easy to smog as long as... -
Found this in my binder of info for my truck. Apparently bright wiper arms were stock. It's on the right column at the bottom.
-
Bought a clean ‘82 C10 off of a coworker. I’ve been pestering him to sell it to me for years! He finally caved after his DD PUp was...
-
My wifes Olds 98, thing has 8-9 ash trays lol.
-
Goldie Driver reacted to TCulpepper's post in the thread All time 4x4 / NP203 Truck Questions, hard to make tight turns with Like.
I didn't drive the truck much, and now that I think about it, I may have only been making sharper right hand turns on the route I took...
-
Goldie Driver replied to the thread All time 4x4 / NP203 Truck Questions, hard to make tight turns.My 1st instinct would be to see if it is in Loc as that will cause it to fight on turns. Both ways, however, not just right. Just get...
-
Goldie Driver reacted to Mark Jones's post in the thread 1979 NA 350 C-10 Finally Goes Down The 1320 with Like.
UPDATE: Finally ran the 1/4 mile in my NA 350 long bed C-10, the conditions: 95 degrees, 120 grains of water, 29.40 Barometer, 3590 DA...
-
Howdy, new to the forums - would be lying if I said I hadn't been on here when identifying some issues with my truck, but never posted...
-
Finally got the right utube video for this project, thank you
-
BTW there is a gentleman on Etsy making vinyl versions in stock looking form and different color variations to better fit the color of...
-
-
Loading…
-
Loading…
