Another seat belt question

[pbcasterlin]

I am slowly getting the interior back together and am installing seat belts I got from LMC.
The shoulderd 1/2 x 13 pillar bolts...did the have a spacer with them ? If they did I put them somewhere I was sure I would remember lol

 

[pbcasterlin]

Even better would be if someone could post a picture of the shoulder belt bolted into the "B" pillar with the plastic cover removed. I just want to make sure I am not missing anything.

 

[Torrey]

I think I ran into the same issue as you using the LMC three point belts. The hardware they send with the retainer was much smaller than my factory bolt. I used the factory bolt, but there was about a 1/4" gap between the belt "triangle" the head of the bolt and my interior trim. I ended up using a rubber grommet just to keep it from rattling.

 

[zulander]

Nice call on the rubber grommet, will help keep your sanity.

 

[Dleslie212]

Does anyone happen to know the size of these bolts? I need to grab some replacements - i removed my old bolts and few years ago and cannot find them now

 

[bucket]

Does anyone happen to know the size of these bolts? I need to grab some replacements - i removed my old bolts and few years ago and cannot find them now

It just so happens that I have this sheet that is dated '77.

You must be registered for see images attach

You must be registered for see images attach

 

[Dleslie212]

Thats pretty awesome - thank you. Inordered some from Amazon but it's nice to know I ordered the right size

 

[Dleslie212]

1/2-13 x 1.30 with shoulder is the correct size for my 77, by the way - for any future Googlers. Second picture posted above, bottom left corner