Whats the driveshaft length in a 76 C30 Single Cab Manual Trans
- Thread starter GClapp
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
PrairieDrifter
Full Access Member
- Joined
- Dec 28, 2014
- Posts
- 3,463
- Reaction score
- 4,577
- Location
- North Dakota
- First Name
- Mason
- Truck Year
- 84,79,77,70,48
- Truck Model
- Suburban k10, bonanza k10, c30 C&C, c10, gmc 1/2ton
- Engine Size
- 350, 350, 350, 350, 350
If it's two wheel drive it would have probably had a 2 piece driveshaft, with a splined slip shaft at the hanger bearing. It would have had fixed yokes on both ends of the driveshafts for sure. A driveshaft shop will want the measurement from axle yoke to transmission yoke. Then they will be able to advise if you'll need single or two piece driveshaft.
Theyll probably be 1410 ujoints but don't take my word, I just got into my first one tons the last couple years lol
Similar threads
