What size/length/thread pitch bolts for brace on NP208 transfer case?

[Mike Gresham]

Those bolts are M16-25 and are readily available at your local John Deere tractor store. Remember to use blue LocTite.

You must be registered for see images attach

 

[Steelbuddha]

Those are beefy bolts and not a lot of shear forces on them for the size imo.
I wouldn’t be scared of not using high strength bolts.
I don’t doubt that Vato Zone and Homie Deport don’t have them.
Do you have a local hardware store with a good selection of nuts n bolts?
Assuming the bolt in the pic is the wrong size even though that looks like a 208 to me?

In the future, I will never refer to it as anything other than Vato Zone. Brilliant.

 

[Craig Nedrow]

If you have some calipers, just measure the hole dia, and then compair it to a tap drill chart. Don't have a tap drill chart? get on, everyone should have on, and a pair of calipers, saves time. From your friendly local machinist.