Turbo 350 and np208

[Chevy7979]

Ok, so probably a stupid question but I'm a newbie. A few weeks I picked up a turbo 350 out of a junkyard to replace the one in my 81 K10 that's shot. This past weekend I finally got around to dropping the trans out of the truck along with the transfer case. When I unbolted the adapter I noticed the output shaft on the transmission was longer than the one I had just bought. I did some reading and from what I found apparently the output shaft on the transmission is longer for the np208. Is there a different adapter I can buy to get the shorter output shaft on the turbo 350 I bought to work or am I going to need to do a transfer case swap? What's my best bet?

 

[bucket]

Nope, your options are to get the correct output shaft for the trans (uncommon these days) or run an np203 or 205 from behind the th350.

I can't remember for certain, but I think you can use a 2wd th350 also, as long as it has the short, car style output.

 

[MadOgre]

Im pretty sure Advance Adapters could hook you up but it would probably cost more than a new transmission