14 bolt ff g80?

[mr79k25]

I have a 79 k25 with a full float 14 bolt that needs new clucthes. Where might i beable to get a rebuild kit for it? To the best of my knowledge its all original.

 

[crazy4offroad]

May check the dealership, believe it or not.

 

[HotRodPC]

G80 Gov Bomb in a 14b FF? Uses clutches? I didn't think G80 used clutches. Locking Diffs usually don't, but Limited Slips Diffs do. How about Randy's Ring and Pinion?

http://www.ringpinion.com/DiffWizard.aspx

 

[crazy4offroad]

G80 Gov Bomb in a 14b FF? Uses clutches? I didn't think G80 used clutches. Locking Diffs usually don't, but Limited Slips Diffs do. How about Randy's Ring and Pinion?

http://www.ringpinion.com/DiffWizard.aspx

Endorse ANYONE besides those dickfaces. After the return fiasco those bastards put me through I wouldnt buy ANYTHING from those bastards.

 

[HotRodPC]

Oh really??? That was them who did that ****? I remember you went to hell and back over an exchange, but didn't realize it was these guys. It seems you ate a set a gears because you goofed and agreed too, then you ordered the right stuff and they sent you the wrong stuff and you didn't realize it until it was part way installed and they woudln't take the **** back even though they were in the wrong that time. And then wanted you to eat 20% restock fee and pay shipping again both ways. Something of that nature. These guys are the ones that did that to you?

 

[crazy4offroad]

They shipped it out of central U.S. at about $12 cost for THEM to ship but when I had to return it went to ****** Washington state (I'm on east side of the country), at $35 or so return ship on MY dime, plus 20% restock fee which ended up altogether ******* me out of nearly $80 on a $200 R&P set. Randy's R&P! *********!!

 

[mr79k25]

No luck at the dealership they were discontinued 9 years ago!

 

[mr79k25]

I have a few pics on my phone of it. Just gota figure out how to post them.

 

[crazy4offroad]

If you read here you might see parts to rebuild it (if you can find them) are cost prohibitive. You'd be better off getting an LSD or locker from the aftermarket selection.
http://www.pirate4x4.com/forum/showthread.php?t=582864

 

[hirschdalechevy]

I would go get an open carrier and slap a detroit locker in there , then you are good to go . You can find 14 ff's at pick and pull with open carrier's for around a 100 buck's complete .

 

[mr79k25]

I put a few pics in my album. Kinda thought with a 14 bolt full float that wasnt open that i was on to something. Guess the new carrier bearings i had my machine shop put on are no good now being i cant get clutches for the rear.

 

[crazy4offroad]

The bearings should still be good, if they can remove them carefully.

 

[mr79k25]

Where can i find a open carrier?

 

[hirschdalechevy]

The bearings should still be good, if they can remove them carefully.

Agree^^^^^^^^^^^ , I would go the detroit way and gut a cheap open carrier from pick & pull.

 

[crazy4offroad]

Hey lookin for carriers i found a clutch kit for the G80, or I THINK it's for the G80...
http://completeoffroad.com/i-760466...lates-for-gm-14t-and-10-5-ypkgm14t-pc-14.html
You should call and verify. An open carrier with sides, spiders and crosspin should be dirt cheap at the junkyard. They want $250 and up just for the bare carrier on completeoffroad.