Search results
-
F
SBC intake manifold gasket
what do you guys do when swapping intake gaskets? i currently have felpro 1205's with "the right stuff" gasket maker for the front and rear seal, but it looks like its blowing oil out the back, so going to change it out. this is the 3rd or 4th time in 8 years, seems a bit much? anyone do...- frankenstien
- Thread
- Replies: 9
- Forum: Engine & Performance
-
F
17x9 with 315's on a 4'' lift?
long story short, my 285's are wore out, they were stretched on 7'' rims, looking to go up to 315's to match my 4.56 gears, found a guy with good used set of 6 315/70/17 load range E's with 60% tread, its a pretty good deal i need to get wheels anyways, looking at some pro comp 17x9 with...- frankenstien
- Thread
- Replies: 3
- Forum: Wheels and Tires
-
F
wheel hop solutions few other ???
so heres what i have... a 1974 gmc k15 with 3/4 ton axles. D44HD/FF14bolt with 4.56 gears, it has a lockright locker in the rear. currently has some sad 285/75/16 cooper discoverer ST's, right now they are measuring 31.5'' tall 4'' suspension lift, springs in front, ORD shackle flip in the...- frankenstien
- Thread
- Replies: 22
- Forum: Lifted & Off-Road Systems
-
F
new transmission, slipping, help diagnosing
ok so i have another thread here http://www.gmsquarebody.com/forum/showthread.php?t=14731 had the intermediate sprag race explode. ok so i just got it back in, my clutch pack clearances were good, but as of now, it shifts hard from 1-2(supposed to) 3 is firm, not hard, it wasnt before. but...- frankenstien
- Thread
- Replies: 19
- Forum: Automatic Transmission
-
F
Th350 fwd clutch clearance issues/suggestions
Ok, putting my th350 back together finally. I have 2 books, one says clearance is .010-.080, some builders perfer keeping clearance to .010-.025- ron sessions book. The other says clearance is .020-.040, any tighter it will creep in drive.- sa design workbench series. My forwards spec...- frankenstien
- Thread
- Replies: 3
- Forum: Transmission & Transfer Case
-
F
leaking axle tube
i have an 8 lug dana 44 under my truck in the front, it has started to leak gear oil where the tube is pressed/spot welded into the pumpkin. anyone have any luck fixing this with something other than a Dana 60?- frankenstien
- Thread
- Replies: 26
- Forum: Differential & Driveline
-
F
A few TH350 questions
Ok, back story... so as you can see from the pictures, i decided to relocate my intermediate roller clutch/sprag into the pan, and that race wasnt happy being 1 piece. that was a TCI hardened race. the 1-2 accumulator spring broke and hammered the piss out of the accumulator piston, as well as...- frankenstien
- Thread
- Replies: 14
- Forum: Automatic Transmission
-
F
New guy from Alaska
hey, probably should have joined up along time ago, i have a 74' gmc thats been pieced together when i was 21ish, made a truck out of it, the body isnt supre grea, had a damaged frame, but it has a 10.5:1 383 with a retro fit roller cam, dart heads, etc, th350 built by me 205 t case, FF14...- frankenstien
- Thread
- Replies: 3
- Forum: Introduction
