Search results

  1. G

    Front & Rear end Swap Question??

    Ok so I was checking on craigslist and a guy near me has a set of front&rear axles compleat for sale says the front is a dana 44 and rear is a 14bolt 10.5 inch 8 lug full float and both axles have 4.10 gears. He said the guy he got them from pulled them from a 78 suburban. Now will...
  2. G

    Rear Disc Brake On K2500??

    Is this possible to do on a k2500 8 lug truck? I'm pricing a compleat overhaul on rear brakes and it's pretty costly if I could do a disc brake swap I much rather do that.
  3. G

    Rear Axle Bearing Play Some or None?

    Ok so should there be any play in the rear outter axle bearing or none? I have a little bit doesn't seem to be a lot tho. There is no leaks from the seals.
  4. G

    Shock Boot On Driveshaft?

    Ok so I was thinking on my front spline joint on front driveshaft would it be able to put a shock boot on there to keep unwanted mud/sand/ect out of it with out it bothering the driveshaft?
  5. G

    Damn Hubs

    Ok so I've got an issue I think? I got locking hubs and I noticed when's removed hubs for inspection, I only have a spring on the pass side behind hub as the driver side I don't ? Do I need 2 or none at all? And I think my pass side hub isn't working proper do to missing parts. Does anyone...
  6. G

    Locking Hub Question?

    Ok so I noticed on my pass side with tire off ground and in locked position it doesn't spin the driveshaft to the t-case? The front axle it self is spinning so no broken u joint. Also I noticed the driver side doesn't have a spring behind the locking hub as the pass side does but that side...
  7. G

    Does Your Exhaust Exit Rear Under Bumper? Kit?

    Ok so my plans are once the weather gets nice is to install some summit headers on my truck and run duel exhaust stright out the rear under the bumper. I've been looking for kits online but can't seem to find any? Does anyone on here have the same setup on there truck?
  8. G

    Help Want A 4" Suspension Lift With All New Springs

    Ok so my 86 gmc k25 has 33's on it now and is stock hight. I'd like to go with a 4" lift just to make more clearance when off the road and in incase I wanted to add larger tires in the future. Also the fact that I don't really want to start messing with driveshafts and pinion angles and a t-case...
  9. G

    Ball Joint Replacement First Time!

    1986 GMC Sierra k2500 Ok so I found that my pass side Lower ball joint is bad and needs replacing. I know in order to remove it I must remove the following? Wheel Caliper/brake pads Locking hub Lock nuts Spindle 6 housing nuts then housing Axle shaft Now this is my first time ever...
  10. G

    Shaking While Stopping??

    Ok I've been driving my truck I got about a month ago and I noticed while coming to a stop applying brakes at say 45-50 mph the truck starts to shake wth? It doesn't seem to do it when I first drive it it seems when the parts warm up it starts. There's no pulling in the steering wheel and I can...
  11. G

    Engine Bay Wiring Removal Help

    Ok so I'm looking to clean up the engine bay on my k2500 Sierra 5.7 I want to remove all the unnessasary wires the a/c is removed the emissions removed has manual choke. I noticed a lot of plugs just laying around and I don't need them I'd like to remove them. I want to unplug the engine...
  12. G

    Np208 Won't Shift Into Neutral Or 4 Low?

    I bought my 86 k25 and it won't shift into neutral or 4low I can shift from 2wd to 4high but it won't go any more. I don't want to jam it and f$ck it up as this is my daily driver and I have no garage right now. It shift fine from 2wd-4hi / 4hi-2wd I'm new to t-cases and would hate to have to...
  13. G

    Engine Bay Clean Up & Charcoal Canister Removal Help?

    I'm cleaning my engine bay out of all un needed stuff the a/c parts were bad so I all ready removed the lines/ condenser /accumulator / pump. The smog parts are all removed ( don't need for inspection here) and I have a edelbrock carb. My question is the charcoal canister can I remove that...
  14. G

    Newbi Transfercase question?

    I'm kinda new to transfer cases I got a 86 gmc k2500 700r4 trans 5.7 engine can some one tell me what t case I have and is there a better/stronger one that will interchange with this? I'm asking because my current t case semi works 2wd work and 4 high but won't go into N or 4 low. And...
  15. G

    New From UpState NY 86 GMC Sierra 2500

    Hey guys I'm new here from way upstate NY I'm about 15 min from Canada and Vermont border. I've had a few trucks since I started driving but never off roaded them as most were 2wd and the ford bronco I had sucked in the mud. Anyways I just bought a 1986 GMC Seirra 2500 v8 350 auto I...

Latest posts

Forum statistics

Threads
42,292
Posts
913,142
Members
33,792
Latest member
Twistedwhisky
Top