Search results
-
Heat shield
Anyone remove the heat shield that is under the driver side foot/ seat? It attaches to the frame, and the seat belt buckle bolt. I don’t have the nut for the seatbelt buckle bolt and can’t find the thread and pitch. Don’t want to remove it and pretty sure it is metric. The heatshield looks like...- Senck243
- Thread
- Replies: 0
- Forum: Engine & Performance
-
Dual tank problems.
Complete fuel system is new. Had both tanks working and now only the drivers side tank is working. When I switch the tanks over, it seems to stay on the drivers side. Valve is new, switch is new both tanks and pumps are new. Any help is appreciated as to where to start Sent from my iPhone...- Senck243
- Thread
- Replies: 7
- Forum: Engine & Performance
-
87 tbi exhaust manifold pipe plug
Going over my truck and fixing all the half assed fixes that have been done. My dilemma now is the passenger side manifold. When the smog was deleted the tube out of the #2 cylinder was just cut and pinched closed. Want to plug it but can't find a plug. Seems like 5/8 od 18 thread count. Any...- Senck243
- Thread
- Replies: 39
- Forum: Engine & Performance
-
Window rehab
Have my doors apart to rebuild vent Windows and put new channels and felts in. Also changed the motor and regulator. Question is putting back together should I put the vent window in first or the glass and regulator? Thanks in advance Guys. Sent from hell -
Cruise control
Just picked up an 87 Silverado swb 2wd and the rod for the cruise control is missing. Saw some on eBay that are different measurements. Does any one know the length of the one needed for a small block. Thanks in advance. Sent from my iPad using Tapatalk- Senck243
- Thread
- Replies: 2
- Forum: Engine & Performance
-
Carlisle all truck nationals 2013
Anyone going? Ill be there all three days Sent from hell -
Hydro clutch replacement
I believe what I have is the three finger style. My question is the replacements seem to not be? They have alot more. Is this just a new design or will it make a difference. Thanks Sent from hell- Senck243
- Thread
- Replies: 5
- Forum: Manual Transmission & Clutch
-
Input seal and clutch sm465
Input shaft seal leaked and oil soaked the clutch. So yesterday I took the transfer case(208) and the tranny out. I and gonna put a whole new clutch and flywheel slave cylinder and throwout bearing in. Also my rear main is seeping so I am gonna replace that as well. Anything else I should do...- Senck243
- Thread
- Replies: 5
- Forum: Manual Transmission & Clutch
-
New from New York
Hey guys new to the site and will be looking for advice on my 84 k10 project. Looks like a very informative place. Thanks Steve Sent from hell- Senck243
- Thread
- Replies: 6
- Forum: Introduction
