Search results
-
B
Stepside fenders
I was wondering what years did gm make fiberglass rear fenders? Just only come on dually boxes or regular step side boxes get them also in certain years? I know the two fenders are different also. -
B
Bell crank bracket
Anyone know were I can get a Bell Crank Bracket at? I had a auto trans and I put in a sm465 with a mechanical clutch. I need the bracket that is riveted or bolted to the frame that supports the bell crank or z-bar. I can't find that bracket anywhere. I went to 2 junk yards and called 4 other...- BigAl285
- Thread
- Replies: 2
- Forum: Manual Transmission & Clutch
-
B
TH 350 Torque Converter
Im just putting my truck back together after swapping the frame. Took my truck for a little test drive to say I did and it wont go into gear with out stalling. I checked all vacuum lines, module on the trans all check out good. I replaced the vacuum line going from motor to trans. I switched...- BigAl285
- Thread
- Replies: 29
- Forum: Transmission & Transfer Case
-
B
Edlebrock (1411) 750 carb jetting
I have a 383 stroker, 11.5 to 1 compression, cast 202 fuelie heads, port, polished, milled, cam is lunati 504 lift, Edlebrock RPM air gap intake. I don't have the cam card here at my house. Here is the issue I am having. I have a Edlebrock (1411) 750 carb on it. Doing some dyno runs on it. It...- BigAl285
- Thread
- Replies: 7
- Forum: Engine & Performance
-
B
mini vs full spool????
I have a 75 GMC 3/4 ton 4x4 dana 44 front and a 14 bolt rear. I'm building a truck puller / street truck. What do people run in there rear ends for locking them in? mini spool, full spool carriers, or a locker (detroit or a eaton)? I still want to drive it, I've been told to weld the spiders...- BigAl285
- Thread
- Replies: 18
- Forum: Differential & Driveline
-
B
rocker noise
Hi. I bought a 383 stroker from a guy last year. brand new never ran. The guy needed money, I got screwed on it big time. Motor is nothing but trouble. Bottom end seems fine. Too much top end noise. Motor came with 488 lift comp cam, screw in studs, aluminum heads. Locking nuts with the set...- BigAl285
- Thread
- Replies: 26
- Forum: Engine & Performance
-
B
TH 350 Issues
I'm a newby here, I like the site been here many times just never posted. I have a 75 GMC 4x4 33'' tires, 383 stroker putting out 500 hp and a 2500 stall. I have a TH350 trans. I'm setting it up for truck pulling. My truck came with a TH350 trans and I thought I'd give it a try with the whole...- BigAl285
- Thread
- Replies: 10
- Forum: Automatic Transmission
