Search results
-
Flex plate questions.
I'm about to replace my flex plate. It chewed up a new starter in less then a week. I had to rush putting in tthe new starter, and honestly was my first, so I know it wasn't shimmed quite right. Didnt have time to take off the bell housing to inspect the flex plate either. All that together...- Turt13
- Thread
- Replies: 35
- Forum: Tech Discussion
-
She's got the shakes, need help locating the cause.
Ok, so here's what she is: 81k20 4x4 350 w/ 1406 eldelbrock carb, some off brand or homemade headers, t400, np208 case Here's what she's doing: Starts right up, usually. If not, she will with a little throttle. She's got a rough-ish idle. Can't tell if it's the idle for sure though, motor...- Turt13
- Thread
- Replies: 76
- Forum: Tech Discussion
-
Where's Wyoming? (81 k20)
Figure since I'm on this site enough, and am currently working on my truck quite often, I'd introduce myself, and icky vikky. I'm Travis, and Vikky is my beat up, neglected, charity-case chevy. She's a1981 3/4 k20, with a 70s bed. Her and I have been in this really strange relationship for a...- Turt13
- Thread
- Replies: 27
- Forum: Introduction
