Search results
-
Does anyone recognize these?
Is Bucket EVER wrong ?- Ken B
- Post #4
- Forum: Stereo & Entertainment Systems
-
What have you done to your square lately??
Did some undercoating and satin black painting of inside of inner fenders and undercoating on bed wheel wells -
Stepside Bed Question
I am looking to do some spray on undercoating on the underside of my stepside fenders. I am assuming that I should NOT spray the seam where the fender meets the bedside so it can drain any moisture. Is this a correct assumption?- Ken B
- Thread
- Replies: 1
- Forum: Paint and Body
-
-
-
Square body meet Richmond Indiana
Anyone attending please take pics for those of us unable to attend. -
Need help with lights
I have been lurking on this thread, just re installed my fuse block and starting to re install the wiring , I will be back begging for help I am sure. I am already getting my mindset,,,,run 1 circuit get it working and stop. Gonna take a while but no tools will fly across the garage...- Ken B
- Post #15
- Forum: Electrical & Audio
-
ID this rocker step hole for me
Rust proofing like a company called rust check they drilled dozens of holes and injected oil like substance then it would rip/drain for hours on a lift- Ken B
- Post #6
- Forum: Paint and Body
-
Proud New 1976 Square Body owner!
Welcome from Indiana. Lots of good information around here. I have been sucking info up as much as I can- Ken B
- Post #6
- Forum: Introduction
-
Door Conduits
does anyone have any feedback on the HD Wiring Harnesses from LMC,,,,good/bad ? easy to install? tips?- Ken B
- Post #18
- Forum: Electrical & Audio
-
Square body meet Richmond Indiana
this happens each year when we vacation......and its so close and I bought a vehicle from the founders....stinks i miss it -
Door Conduits
just rehung my doors....all my door bolts were "temporarily misplaced" after lots of cleaning found them in the bottom of a 5 gallon bucket, so I hung the doors and looking into the wiring....I have LMC HD wiring harnesses and factory wiring is in tact. Heating up outside so doing indoor...- Ken B
- Post #17
- Forum: Electrical & Audio
-
-
SOLVED:Truck boggs down when accelerating
I once had a very old cat. That the Insides would shift and plug the outlet of the cat.- Ken B
- Post #5
- Forum: Tech Discussion
-
-
-
Glove box issue
tagging onto this thread....same project. but how do you separate the latch/lock so you can then replace the plastic "tub. my latch is a little loose in the metal glove box door but I can not see how to separate the latch......any help would be appreciated -
-
Hvac blend door question...
tagging on this thread. so as I am reassembling the heater box and controls, the controls wont go all the way to the off position. which cable is out of adjustment? it is conected to 2 cables....- Ken B
- Post #4
- Forum: Tech Discussion
-
-
new member from MN
Welcome. You are correct lots of good information and helpful people- Ken B
- Post #2
- Forum: Introduction
-
'85 C10 Door Removal
I didnt tackle vent windwos sent them out to be rebuilt- Ken B
- Post #12
- Forum: Paint and Body
-
New to Square Body
Welcome from Indy, lots of good information and help here. Please put some pics up when you get your truck , I am working on an 81 stepside. Interested in step sides especially.- Ken B
- Post #2
- Forum: Introduction
-
-
Firewall Steering Column grommet
I am gonna try putty tape to seal.- Ken B
- Post #7
- Forum: Suspension, Steering & Brakes
