Search results

  1. Rickf

    1985 K20 Temp sending unit location?

    I thought the sending unit should be in the driver side head or intake coolant crossover.
  2. Rickf

    Another one to Watch… ‘83 K20

    Do I see an a/c delete plate on the firewall?
  3. Rickf

    Bent frame 1987 4x4 short bed halfton

    Is it a C20 or K20? Huge difference on the next step.
  4. Rickf

    Bed interchangeability

    I put an bed on a c&c, with the rear tires centered in the opening there was a larger than "normal" gap behind the cab.
  5. Rickf

    1978 Chevy C10 w/ IL6 4.1 tranny questions

    If it was me, I'd look into a Gear Vendors OD unit, not cheap, less work than a gear swap.
  6. Rickf

    Blower motor wont turn off

    Some year squares are always on low. Is "off" missing from the heater/defroster control?
  7. Rickf

    Camero parts

    If it's not to cold tomorrow I'll take a look, I have a couple of '69 camaro's and a '74 K20.
  8. Rickf

    Help!!! With getting main bearing to roll in

    If you have a standard transmission maybe the input shaft is holding the crank up, if an automatic maybe it's the torque converter/flexplate.
  9. Rickf

    Help!!! With getting main bearing to roll in

    I'm not sure if loosening every bolt that holds the crank in place will help, (from the balancer to transmission)
  10. Rickf

    1974 K20, SM465 manual,203 transfer case,350 engine…what is the clutch disk size? I’d like to order it before pulling it.

    My '74, 350,SM465, & 203 has a 12" clutch.
  11. Rickf

    lock plate retaining ring

    I bought mine new, don't recall which vendor, LMC maybe.
  12. Rickf

    HOW TO INSTALL A TACH METER IN A 1986 K10 CHEVY TRUCK WITH 6,2 LT ENGINE

    Buy an autometer diesel tach part #3788, clamp the pickup to the housing, follow the instructions and you are good to go. KISS, there is no need to re-invent the wheel.
  13. Rickf

    Firewall Rust

    I thought the drains could be seen with the fender off.
  14. Rickf

    HOW TO INSTALL A TACH METER IN A 1986 K10 CHEVY TRUCK WITH 6,2 LT ENGINE

    The tach that I put on my 6.2 NA had a pick-up that clamped to the housing. I don't recall where I bought it or what brand, ask mr. google.
  15. Rickf

    WANTED: Interior trim pieces 86 C10 Preferably Beige/Tan color and Door panels

    I've had doors for my '37 GMC shipped via Greyhound Bus from CA to MA. I don't recall the cost but I didn't have heart failure. A bunch of plastic parts shouldn't be a big deal. I needed to pick up at the closest bus terminal, just a thought.
  16. Rickf

    14 bolt 10.5 full float on 1/2 ton

    You could hang a Gear Vendors OD unit onto the TH400.
  17. Rickf

    Anybody know how to clean this?

    I've had pretty good luck with "Gunk" engine degreaser. Smells a lot like kerosene and safer than gasoline.
  18. Rickf

    3/4 ton studs on half ton help

    If on a budget, pop out a good stud to measure and match it up at your local parts store. Don't be surprised if it a 12m x 1.5.
  19. Rickf

    Direct power headlights need fuse?

    The kit I installed came with a 30amp fuse. I thought the lighting came from a fusible link off the starter solenoid.
  20. Rickf

    Transfer case support bracket

    It goes thru a bell housing hole into the block
  21. Rickf

    Engine threaded bosses

    First pic might be for a clutch linkage pivot bracket. Bottom hole in second is oil dip, not sure of upper holes.
  22. Rickf

    Transfer case identification

    Is it aluminum?
  23. Rickf

    Engine oil cooler hoses

    I have never had good luck with Dorman hoses, whether for a 6.5TD. 6.2NA, or a BBC. I ended up using AN fittings and braided stainless hose. Your results may differ.
  24. Rickf

    86 c10 Driveline is too short

    What about having a driveshaft made up?
  25. Rickf

    Help identifying under dash connector

    If it's a 1500 with a 305, most likely came with a 700R4 and has been changed to a th400. What does the gear indicator have for letters?

Latest posts

Forum statistics

Threads
45,947
Posts
996,623
Members
39,141
Latest member
jbwhitford
Top