Search results

  1. CoggedBelt75

    New member from Louisiana

    Looks to be a solid start for ya. More pics if you have them.
  2. CoggedBelt75

    Lost spark

    I'm assuming it's wired like this
  3. CoggedBelt75

    Lost spark

    Lots of people think since it doesn’t start they aren’t getting spark. So...I have to ask, what makes say you haven’t any spark? Did you pull the coil wire from the distributor and place it by a ground to see if it sent a spark when cranking it over? That would eliminate the coil. Or then pulled...
  4. CoggedBelt75

    What have you done to your square lately??

    Man, I can relate to this!
  5. CoggedBelt75

    Ford Trash Talk Thread lol

  6. CoggedBelt75

    Spark plug wire opinions

    MSD 8.5 mm cut to fit wires with 90* boots except a straight on #5, Design Engineering sleaves, and Billet Specialties looms. Have run Taylor Spiro-Pro cut to fit in the past and they held up to the heat well.
  7. CoggedBelt75

    New member from Tucson, AZ

    Nice ride you have there. I’m assuming the color is more the top pic than the bottom? My truck is Gypsy Red, but depending on the light, can look orange also. Do you happen to know what your color actually is.
  8. CoggedBelt75

    Column Mounted back up light switch

    Old thread from this site. Here’s 2 pics that should help with the link they came from. https://www.gmsquarebody.com/threads/neutral-switch-replacement-adjust-help-needed.10266/
  9. CoggedBelt75

    Ford Trash Talk Thread lol

  10. CoggedBelt75

    What have you done to your square lately??

  11. CoggedBelt75

    What have you done to your square lately??

    Discovered yet another senior moment from last fall. Complete interior makeover. Still like finishing console and installing amps. Put stereo unit in but left the detachable head off. 17 days till cruise weekend so started inside detail. Putting the head on, it just would not connect. Then I see...
  12. CoggedBelt75

    Ford Trash Talk Thread lol

  13. CoggedBelt75

    Ford Trash Talk Thread lol

  14. CoggedBelt75

    What have you done to your square lately??

    I’ve been without one going on 18 years. It may “feel” a bit different cornering at speed tho. You’ll being losing some body roll control. Guess I’m just used to it. Mine’s off to help with launches on straightaways.
  15. CoggedBelt75

    New from North Texas

    Good job! Could you share some more pics, inside and out?
  16. CoggedBelt75

    Newbie trying to park this thing

  17. CoggedBelt75

    Still cannot ID engine

    About the only thing these old dogs are worth
  18. CoggedBelt75

    Still cannot ID engine

    Even a crate will have an engine code, just no vin number. Pictures of what you have may help
  19. CoggedBelt75

    Still cannot ID engine

    Can you post some pics of all the numbers? All engine codes begin with a prefix letter, the date numbers, and end with 3 suffix letters. At least I think it’s still standard practice to still do this.
  20. CoggedBelt75

    What have you done to your square lately??

    Got carbs mounted, synced, and A/F reset. Rattle canned the wheel wells and master cylinder.
  21. CoggedBelt75

    What have you done to your square lately??

    Since the hood’s still off for repaint, which I should have back Sunday, decided to clean the winter crud off everything. Our cruise-in is the 1st weekend of May so I’m running out of time for the bay to be presentable. Took the carbs off to replace all the gaskets below them & polish them with...
  22. CoggedBelt75

    Cranks without starting - ignition?

    Hard to answer the question not actually seeing what you did. Little things usually get left out describing what was actually done. But usually, after making a change and things aren’t what they use to be, then it’s most likely whatever was changed is the culprit. As for the distributor or coil...
  23. CoggedBelt75

    What have you done to your square lately??

    Pulled the hood today so my son can repaint it. I had a senior moment last fall and left a ratchet in the top pulley. Got distracted for a bit. Went to pull her back into the garage. BAM!!! Literally made me sick. Luckily she was cold and didn’t fire right up. Bad thing is this wasn’t the first...
  24. CoggedBelt75

    Wheel & Tire Database: please fill in your info?

    Thanks HR. Several set backs last year, but rebounding pretty good so far.
  25. CoggedBelt75

    Wheel & Tire Database: please fill in your info?

    Vehicle: 1975 short bed Wheel Make: Street - Centerline Fun - Cragar Wheel Model: Street - Convo Pro Fun - Soft 8 Front Size: 15x8 Front Backspace: Street - 4.5” w/.25” spacer Rear Size: Street - 15x14 Fun -...

Latest posts

Forum statistics

Threads
48,667
Posts
1,074,245
Members
43,339
Latest member
Jeremy89
Top