xm20k's latest activity
-
Yes. I’ve seen multi-million dollar machines fired up after maintenance, only to be shut down due to unexplained leaks. Proper sealants... -
xm20k reacted to Turbo4whl's post in the thread Doing away with fuel tank selector valve?? with
Like.
Welcome to the forum. Like @Grit dog stated, when one tank is empty, it will draw air. You will not get the advantage of two full tanks... -
xm20k replied to the thread Doing away with fuel tank selector valve??.Yes, I would highly recommend either a manual valve at some point you will suck air and lose fuel pick up teeing them together or just...
-
Ok, I’ll try again then. My corner holes are blind, just checked. Even still, I put ARP thread sealant on every bolt and it still...
-
xm20k replied to the thread Sealing intake manifold?.Are you sure the bolts are not too long? I've seen that as well they bottom out feel and look like they are correct but just long enough...
-
xm20k replied to the thread Gun Rack Spacing.I don't travel with firearms that can be seen with a quick glance, I also don't put stickers on my vehicles that announce what I may or...
-
I put mine behind the seat,,, got tire of breaking the back glass when out 4wheeling. Bsides no one can see um to steal um.
-
Well, all fixed. My local NAPA shows Spicer in stock, but it's Sunday so they're closed. My local AZ showed Spicer available but not in...
-
xm20k replied to the thread Detroit Speed Engineering versus UMI front coils..Mine had 2" springs and spindles and a rear flip it sat to low with the 2" springs. I couldn't get a jack under it with a flat. This...
-
-
xm20k replied to the thread Sealing intake manifold?.The bolts on the outer ends by the water passages on some aftermarket heads are not blind and can leak they need sealer as well. Ultra...
-
xm20k replied to the thread 1984 350 Starter Upgrade to new style Part number request.Only "GM Style starters" I'll use depending on tooth count needed. Most of the "Delco" listed starters from most parts stores are remans...
-
xm20k replied to the thread Well crap!.Spicer, Moog, or Yukon all available thru Summit.
-
I found out the hard way the wiper switches changed/moved around a little bit down there too through the years along with the gauge...
-
xm20k replied to the thread Hello everyone, I'm Walter; I'm new here..No, No, No, we don't need no more grumpy old guys especially one named Walter! :happy175: Beautiful burb they never were my cup of tea...
-
The '73-'77 bezels were made differently than the '78+ bezels. The earlier ones, if a trim level that got chromed gauge openings, the...
