xm20k's latest activity
-
xm20k replied to the thread Thinking about streamlining my tools..I've been replacing corded stuff most of it is being phased out or has already been discontinued. Never liked most of the early battery... -
-
xm20k replied to the thread Bus Bar Ground.Mine was all messed up from the PO playing amateur electrician along with a lot of the dash harness behind the gauge cluster. I replaced...
-
xm20k replied to the thread Oil pressure sensor?.Because it's in the block drain. Also, that's a knock sensor not a temp or pressure sender. Oil pressure is directly above the oil...
-
-
xm20k replied to the thread Front suspension Jerk.Sounds like a lower ball joint or control arm bushings. The inside wheel in a turn leans into the turn and if either is bad could cause...
-
xm20k replied to the thread Internally v. Externally Balanced 383 ID.Forged at the pen, cast is on the right. As far as balance most likely as it was built 20 some years ago it's probably going to need a...
-
-
xm20k replied to the thread What have you done to your square lately??.I'm glad I only pay tax on the price listed on the bill of sale or the title when it was notarized. Ignore the fact we fill that...
-
xm20k replied to the thread The 4 bolt main LIE !!! Or is it???.3/4 race cam is the one I still hear from time to time. For those wondering where it comes from. compiled by HARVEY J. CRANE, JR...
-
Its getting deep in here lol Every 350 is a "Corvette motor" Pop up pistons Camel hump heads 3/4 cam Bored, stroked, balanced...
-
https://www.gmsquarebody.com/threads/1973-k20-350-to-454-swap.29840/page-3 Post 35. I have abused this locker, behind a modded 454...
-
xm20k replied to the thread Chevy 14 bolt - gov bomb locker???.Open diff everything is just inside where you can't see it. Might be able to look into one of the slots with a light and see the tips of...
-
xm20k reacted to 78C10BigTen's post in the thread What have you done to your square lately?? with
Like.
Tbh i wasnt aware there was a differance lol i should tho.... (face palm) -
Started with some vacuuming and some compressed air and made sure I was starting clean again. Slid in the camshaft, then put the upper...
-
xm20k replied to the thread What have you done to your square lately??.Gorgeous truck but too much anxiety for me. I'm lucky mine is all one color besides the mat black hood let alone that shiny
-
-
xm20k replied to the thread What have you done to your square lately??.That's the Little one the "bug catcher" 3 11/16" Butterflies. Bird 4 3/8" Buzzard 5" No worries it's a muscle truck as long as it...
-
xm20k reacted to 78C10BigTen's post in the thread What have you done to your square lately?? with Like.
I LOVE your truck! Sorry @xm20k , no dissrespect to yours, yours is bitchin lol
