Recent content by wuznme
-
W
Plastic or metal fuel lines?
Using single tank, AN fittings and braided lines. Dual tanks, Gates FI hoses and clamps, no reason to spend money on AN/braided hoses if using pollak valve.- wuznme
- Post #6
- Forum: TBI & EFI Conversions
-
W
what are these numbers?
Production run numbers, so they can keep track for recalls etc... The only number that matters is the 3-digits above, those are the model specific heads; those are 862's- wuznme
- Post #4
- Forum: Engine Swaps (Gas) LS, Vortec, LT1 , etc.
-
W
Fuel Tank Selector Valve needed for 5.3 LS swap
Get 6-port for 87' they list right on the valve 58PSI- wuznme
- Post #9
- Forum: Engine Swaps (Gas) LS, Vortec, LT1 , etc.
-
W
heads are at the machine shop, Gasket question and my new cam
GM MLS - unless trying to change compression then Cometic and At the least, ARP Bolts- wuznme
- Post #4
- Forum: Engine Swaps (Gas) LS, Vortec, LT1 , etc.
-
W
Fuel pump for LS Swap
If you have everything already, the Walbro pump 343 is $82.. have to call to order; only have kit on website. These are exact replacement for 87' sending unit. walbrofuelpumps dot com- wuznme
- Post #19
- Forum: Engine Swaps (Gas) LS, Vortec, LT1 , etc.
-
W
I guess I give up on the windows
Redid my windows, all new regulators, channel, channel rubber and glass. Harness upgrade. The driver window works as should, passenger side will only go to 2in from top; but it comes down super fast, way faster than drivers, like twice the speed. I think the glass may be slightly off in the... -
W
What should I sell engine & tranny for?
Sold my 69k mile 87' 305/400 complete pull out last Dec for $1600, buyer was able to ride in truck before pulled.- wuznme
- Post #27
- Forum: Engine & Performance
-
W
eBay drop out L8T mated to 6L90E thoughts and/or drivetrain suggestions.
The ECU from that purchase will not work (no tuning options without high cost to unlock ECM) you will have to get a E38 ECM. That E38 may or may not work with the 6L90e, matching those up is not impossible just tricky. If moving forward with the L8T, try to get one from a truck not a van it...- wuznme
- Post #11
- Forum: Engine & Performance
-
W
What's the going price on a good 305 engine these days ?
Sold complete 87' 69k 305/400 TBI w/harness back in Dec for $1600- wuznme
- Post #26
- Forum: Engine & Performance
-
W
5.3LS won’t rev?
Have you done everything needed in the ECM for removing all the electronic transmission configuration?- wuznme
- Post #63
- Forum: Engine & Performance
