-
-
TubeTruck replied to the thread Rear gear pattern comments?.I'm going to post mine up here also so we don't have a ton of threads with the same thing. I think this looks good, but this is my first... -
-
Well, just got my transmission rebuilt. Rebuilt the t-case. Put it all back together and it drives fine until I hit exactly 60mph. Then...
-
-
TubeTruck replied to the thread 4l80e rebuild gone wrong....Got it back together and in. It's drivable. Something still doesn't feel quite right, but I'll live with it. If I get on the gas at any...
-
-
You are good...Drilling the pump is fine, i do that on all my builds (same with all my lube mods to those units). You can also leave in...
-
Installing the sprag backwards is a mistake you only make ONCE. One of the first 400s I built I put the sprag on backwards. No 2nd...
-
TubeTruck replied to the thread 4l80e rebuild gone wrong....Just getting back to be able to work on this thing, and I figured out what I did wrong in 2 seconds. I ordered a new forward drum and...
-
TubeTruck replied to the thread 4l80e rebuild gone wrong....Pulled the trans apart. Couldn't see anything obvious other than my assumption. Something was staying engaged. Found that the direct...
-
-
If the L/R piston itself is cracked, l would think he'd have no reverse (depending on location and severity of the crack). I also...
-
Cracked reverse servo piston? Or defective seals on the accumulator piston inside the servo? I don’t have a hydraulic chart handy, if...
-
TubeTruck replied to the thread 4l80e rebuild gone wrong....It came out of a 1998 Suburban with a 454. I took the transmission apart initially because of the output shaft, but it was ready to...
-
-
TubeTruck replied to the thread 4l80e rebuild gone wrong....Np. Thanks. I could use all the help I can get at this point, lol. I'm thinking the first time I rebuilt the t-case I didn't get...
-
I got ya. I’m just trying to think of everything. Don’t want us to miss anything.
-
TubeTruck replied to the thread 4l80e rebuild gone wrong....@NickTransmissions Ok, Quick update. I'll probably be pulling the transmission out this weekend. I took it for a very short ride. It...
-
TubeTruck replied to the thread 4l80e rebuild gone wrong....I'll put it back together tonight after I check that servo and with the new separator plate. The t-case stick is pulled back, so unless...
-
TubeTruck replied to the thread 4l80e rebuild gone wrong....Yes, new sprag was purchased and installed. I remember checking to make sure they spun in one direction and in the correct direction...
-
-
-
Loading…
-
Loading…
