Recent content by tubby0
-
T
No Spark...
How are you checking that there is no spark? Pulling a plug and grounding it? You are sure you have fuel getting to cylinder right? Sent from my Nexus 4 using Tapatalk 2- tubby0
- Post #2
- Forum: Engine & Performance
-
T
Okay another question about wiring
Oh cool, sounds like the consensus is that I don't need to worry about it. Now to get my gauge working! Sent from my Nexus 4 using Tapatalk 2- tubby0
- Post #4
- Forum: Engine & Performance
-
T
Okay another question about wiring
So on top of my intake (edelbrock) it looks like I have my temperate sensor near the thermostat housing but nothing is plugged into it. I do however have a wire plugged into my temp sending unit that should go to my temp gauge in my dash. The hitch is that my dash gauge isn't working. Anyway...- tubby0
- Thread
- Replies: 3
- Forum: Engine & Performance
-
T
New Battery Cables, No Power
That was it! I actually pointed out the O-terminal and said to my girlfriend earlier today, I wonder what that went to. I yanked out all the non functioning A/C, cruise control, and emissions equipment trying to open up my engine compartment a bit leaving a lot of little wires unspoken for...- tubby0
- Post #5
- Forum: Engine & Performance
-
T
New Battery Cables, No Power
Hmm...okay so I tried just reinstalling the old battery cables and still no dice to the locations to which they were installed before, my truck has some interesting wiring from the PO and I wonder if I knocked something loose. I would assume if I know the battery has power and the positive and...- tubby0
- Post #3
- Forum: Engine & Performance
-
T
New Battery Cables, No Power
Alright guys, so I recently became a proud owner of a 86 k10 305/700r4. Anyway I just replaced the battery cables along with fiddling with a few other bits and when I went to start back up the truck is acting like the key isn't in the ignition, don't believe the dome light came back on either...- tubby0
- Thread
- Replies: 6
- Forum: Engine & Performance
