Tank6x2
Latest activity Postings About
-
-
Tank6x2 reacted to PrairieDrifter's post in the thread What have you done to your square lately?? with
Like.
My state has the same system, but our year by year plates ended in 75 or 76. But we also have antique plates for 40 years or older... -
Tank6x2 reacted to fofiddyfo's post in the thread What have you done to your square lately?? with Like.
Had to replace the tank selector valve last/this weekend. What a pain in the arse! The old one was leaking and dripping THROUGH the...
-
Tank6x2 reacted to Radiohead's post in the thread What have you done to your square lately?? with Like.
Ha ha, that is about right. Not quite there yet, but I do have a convoluted method for making the rumbles. So much so, that it's only...
-
Installed my transmission temperature gauge today. The Autometer literature recommended a “short” sending unit if installing it in a...
-
Cleaned up the 203 transfer case. Changed the 30 weight oil while I was at it.
-
Tank6x2 reacted to ChuckN's post in the thread What have you done to your square lately?? with Like.
Went for a cruise in the country, checked the local stores for die casts. Then stopped by my buddy’s house for a game of pool and some...
-
Tank6x2 reacted to Radiohead's post in the thread What have you done to your square lately?? with Like.
And all this is without putting one single mile down with it yet. In 3 years now. I can imagine that the list will grow after the...
-
Tank6x2 reacted to brooksman9's post in the thread What have you done to your square lately?? with Like.
Lots of polishing today. About half done. Not fantastic but I think I can live with it. I'm too tired to sand and polish anymore.
-
Tank6x2 reacted to Radiohead's post in the thread What have you done to your square lately?? with Like.
I wondered how I was going to remedy the PRNDL problem I discovered, where the radius is in the cluster housing to change direction for...
-
Tank6x2 reacted to Sad Sack's post in the thread What have you done to your square lately?? with Like.
Finally in primer waiting on paint.
-
Tank6x2 reacted to Chris64's post in the thread What have you done to your square lately?? with Like.
:oops: I sure did...err...tonight. So that line going to the coil isn't 12v? TIL.
-
Tank6x2 reacted to JamesSam's post in the thread What have you done to your square lately?? with Like.
Lot of work left to go.
-
Tank6x2 reacted to JamesSam's post in the thread What have you done to your square lately?? with Like.
Began stage 1 of several small stages of "cleaning up" the engine bay. Just a little bit this time.
-
Tank6x2 reacted to brooksman9's post in the thread What have you done to your square lately?? with Like.
Not horrible but I'm not going to win any Good Guys awards either. Kind of resembles the way they came from the factory. Only this front...
-
Tank6x2 reacted to Phillippio's post in the thread What have you done to your square lately?? with Like.
Nice long weekend to put in a Edelbrock Performer intake and general top half clean up. I also replaced a leaking freeze plug. NOT...
-
-
Loading…
-
Loading…
