Recent content by OYMC
-
2007 5.9 24V Cummins into a 87' C30 Square
Thank you!:happy160:- OYMC
- Post #5
- Forum: Diesel 6.2, Conversions Cummins, etc.
-
-
-
Dash Speakers
I used Polk Audio 3 1/2 speakers for the dash... Here is a video of my 88' K5 blazer that shows the interior and stereo system: http://www.youtube.com/watch?v=kMUMAJiYMxM- OYMC
- Post #28
- Forum: Stereo & Entertainment Systems
-
leveling truck
If you're handy with a little fab work then build a set of 1" longer front shackles... Here are a few pictures of mine... Built from 1/2"X2" flat stock steel... Cost around $20 for the steel... By adding a slight lift to your shackles you will slightly increase your caster angle which will give...- OYMC
- Post #3
- Forum: Lifted & Off-Road Systems
-
What have you done to your square lately??
Atlas 3:1 Installed behind my G56 6 speed manual trans Cummins drivetrain! Oh boy the count down begins! -
New to forum and driveshaft angle ?
This will help address drive line angles but will cause the truck to be a bit squirrelly on the road. By rolling your front axle so that the pinion rises you reduce your caster angle. A positive caster angle will insure stability (This is the angle that attributes to the steering returning to...- OYMC
- Post #8
- Forum: Lifted & Off-Road Systems
-
New to forum and driveshaft angle ?
These photos will again help explain what angles I am referring too: The CV diagram is accurate for most 4X4 6" plus lifted trucks with exception to the axle pinion to drive line angle. The axle pinion should be rolled downward 6-8 degrees from the shown angle. Hope all of this helps...- OYMC
- Post #7
- Forum: Lifted & Off-Road Systems
-
New to forum and driveshaft angle ?
I wouldn't be to concerned with your driveline angle with a 6" lift. If your truck was a short bed you may consider setting your drive line angle but you should be perfectly fine... The first photo shows my 1988 K5 blazer (Short wheel base of course) with a skyjacker 8" lift. The rest...- OYMC
- Post #6
- Forum: Lifted & Off-Road Systems
-
2007 5.9 24V Cummins into a 87' C30 Square
Okay, here is a link to my facebook picture archive of my 1987 GMC Crew Cab Cummins build: Please be sure to "Like" my site if you in fact "Like" what you see... I'll post details at a later date when I'm in a typing mood LOL... Click link below: OYMC- OYMC
- Thread
- Replies: 7
- Forum: Diesel 6.2, Conversions Cummins, etc.
-
-
-
OYMC From Nor CAL
So, My name is Josh and I own / operate a fabrication shop in Northern, California. I currently belong to two other Square Body GM truck related forums which both are quite addicting to say the least. Nothing like a virtual GM truck hang out site LOL... Anyway, currently I am building two...- OYMC
- Thread
- Replies: 16
- Forum: Introduction
