Yeah they gave me a printout but I left it in my truck and haven't been back to get mine yet. Took it in for an alignment because the Camber was noticeably out just bye the eye and and it is pulling to the right. Havent driven the truck enough to know about uneven tire wear.
Doubtful the arms are bent because both sides are the same. I am all to aware of the wheel bearings but everything in the front end is new. Seriously want to do a SAS on it but I cant find a furd front differential here for anything. Maybe I just have better friends then people with furds :dogpile:
Yes you are correct 96 vortecs do have mechanical pump provisions, However its only the casting, they are not drilled for the pump pushrod, and the cam is not eccentric for the mechanical pump.
Took my daughters truck in for an alignment today. They checked the front end out and said all was good so I left, hour or so later they call and say they cant align it because the Caster and Camber are to far out and wont pull in. The knockouts have supposedly already been taken out, and the...
That looks like a pretty close match but. If you take a piece of paper and cut two squares in it slightly smaller then your samples then you can hold the sample behind the 1 hole and the other hole just let the factory paint show through it. Takes the back ground all out of it and puts your eyes...
Ok just have a few concern's.
#1you said the Original cab harness was cut all to hell, and you replaced it with a non cut up one from an 87-88. IIRC 91 cluster's were pinned differently then 87 or 88. Your problem with the temperature gauge pegging sounds to me like your pigtail is crossed up...
http://www.ebay.com/itm/TH700R4-4L60E-KP33900A-PRECISION-REBUILD-KIT-GM-1982-1993-/271931531627?hash=item3f5061e16b:g:~G4AAOSw9N1Vp9SO&vxp=mtr
This kit will have all the seals and gaskets that you will need.
You wont need to buy an additional reluctor ring. The picture of the tail shaft and housing already has the reluctor installed. I would purchase a paper and rubber set which will include all of your gaskets even valve body and pan. I will try to find you a link to the gasket set
ok I am close to having your spreadsheet one. Been waiting to find out on what you were planning, I can go ahead and get it finished up hopefully in the next few days.
I have been pretty busy with working on fixing the body up on my Dodge but I will get you squeezed in there.