Recent content by Nocupsince93

  1. N

    Lower control arms interchange

    I bolted it on and it's very close .. Out by 3/8 of an inch pointing forward , easily within shim range .. I had a local machine shop taper the lower spindle hole to fit the larger ball joint , everything should work out fine .. Plan on bolting it back together this weekend
  2. N

    Lower control arms interchange

    I don't have pictures.. They look very similar and comparing measurements confirms this , however I'm going to bolt the old one on and tie a plumb line to the grease fitting on the ball joint mark it then do the same with the new arm .. If similar this should be enough to seal the deal ?!
  3. N

    Lower control arms interchange

    I'll start this off with a hello .. Then follow with an apology , I think I posted this already in the wrong section anyway ... I purchased a set of upper and lower control arms for my 74 c10 stepside , to replace the worn originals . The uppers are exact replacements however the lowers after...
  4. N

    Lower control arms?

    i ordered a set of complete upper and lower control arms .. The uppers are correct identical to the worn out factory pieces however the lowers are from what I can tell for a C20/30 , they have the pressed in sleeves not the rubber bushings and a larger ball joint stud .. I have a set of Beltech...
See more

Latest posts

Forum statistics

Threads
42,312
Posts
913,507
Members
33,810
Latest member
Garcjay
Top